752909

Silvercrest IAN 306041 SSR 3000 A1 Manual

28
Zoom out
Zoom in
Previous page
1/85
Next page
28 GB/IE
Close the cover of the dust collector 22 , making
sure that it audibly clicks into place, and insert
the dust collector 21 back into the product.
Close the cover 10 of the product, making sure
it audibly clicks into place.
Cleaning the brushes
Regularly remove any hair and dirt from the
side brushes 17 .
Cleaning the main housing
Clean the 3 anti-fall sensors 18 to maintain
their sensitivity.
Clean the front wheel 19 to remove any hair
tangled in it.
Clean the anti-collision sensor 20 to maintain
its sensitivity.
Replacing parts
Replacing the side brushes
If the side brushes 17 are worn out, they can be
replaced with the supplied replacement side
brushes 6.
Loosen the old side brushes 17 fixed to the
underside using a cross-tip screwdriver (not
included in the delivery contents).
Screw the replacement side brushes 6 into
place.
Replacing the HEPA filter
Depending on the frequency of use, the HEPA filter
5 should be cleaned after approx. 15 to 30 days.
After approx. 6 months it should be replaced with
the supplied replacement filter.
Remove the old HEPA filter 5 (see chapter
„Cleaning and storage“).
Insert the new HEPA filter 5.
Troubleshooting /
Problem solving
If the product is not working correctly, the display
1 will show various error codes and emit signal
tones of different lengths. Please refer to the table
below for troubleshooting.
After troubleshooting, press the Clean button on the
robot vacuum cleaner 11 or on the remote control 27 .
Problem Possible
cause
Trouble-
shooting
No function. Battery is not
fully charged. Charge the
battery fully.
Power switch
9 switched to
“O”.
Switch the
power switch
9 to “I”.
Battery contacts
are dirty. Clean the
charging con-
tacts 3 and
the battery
contacts on
the product.
Poor suction
power.. Suction vent 16
is blocked.
Check the suc-
tion vent 16 .
Dust collector
21 is full or the
filters 5, 23
are blocked.
Proceed as
described in
the chapter
“Cleaning and
storage”.
Error code Possible
cause
Possible
trouble-
shooting
E01 Left side wheel
does not turn. Check the left
side wheel
and clean it if
necessary.
E02 Right side
wheel does not
turn.
Check the right
side wheel
and clean it if
necessary.
E04 Product was
lifted up Place the
product back
on the floor
… 28 …


Need help? Post your question in this forum.

Forumrules
1

Forum

silvercrest-ian-306041-ssr-3000-a1

Reset search

  • jeg har fejl e 12 hvad er det,har ikke manual mere Submitted on 6-6-2021 at 17:50

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest IAN 306041 SSR 3000 A1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest IAN 306041 SSR 3000 A1 in the language / languages: English, German, Dutch, French, Polish, Swedish as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info