737513

Silvercrest DTL 1026 IAN 49387 Manual

7
Zoom out
Zoom in
Previous page
1/18
Next page
7
IE
Make sure that no water used for cleaning
penetrates into the ventilation slots, the elec-
trical parts and the drainage hole.
Only use light bulbs of max. 15 W, 230 V, and
fitting E 14.
Preparing the appliance
Basic cleaning
Caution!
Never use agressive or gritty cleansers or
cleansers containing soap, soda or solvents
as they might affect the surface of the appli-
ance.
• Youcanremovethesmell that is inherent in all
new appliances by wiping the interior compart-
ment with lukewarm water with a little vinegar
added.
The right location
Danger of fire!
Do not place any appliance that gives off
heat, such as microwave ovens, toasters
etc., on the appliance.
Do not cover or close ventilation slots.
You need a free space of 54 x 60 x 144 cm (w x d
x h) in which to install the appliance.
To achieve optimum refrigeration with the lowest
possible energy consumption, the location:
– must be a dry, properly ventilated room which is
not too warm.
– must be out of direct sunlight.
A location immediately next to an oven, heater or
radiator is not ideal. Please observe the following
minimum distances:
from electric heaters 5 cm
from radiators, oil, gas and
coal-fired heaters 50 cm
from cooling appliances 2 cm
from washing machines / dishwashers 2 cm
Risk of suffocation for children!
Keep the packaging film away from children
so that it cannot suffocate them.
Caution!
The thermal insulation in your appliance
consists of polyurethane with environmen-
tally friendly pentane insulation foam. Do not
use any electric heaters, scrapers, knives or
other instruments with open flames such as
candles to defrost the appliance. The ther-
mal insulation and interior compartments are
sensitive to heat and might melt.
Leave the appliance in a stable position for
at least 3 hours after installing it, so that the
refrigerant can settle. The compressor might
be damaged otherwise.
When you first put the appliance into use, let
it run for 24 hours without any interruption.
If you happen to switch off the appliance or
pull the mains plug from the socket during
this period, wait for at least 5 minutes be-
fore switching on the appliance again or re-
inserting the plug. The compressor might be
damaged otherwise.
Do not use any caustic or scouring deter-
gents or sponges to clean the appliance.
They might damage the surfaces.
As the interior walls are sensitive to scratch-
ing and to heat, do not use any tools such as
ice scrapers, heat radiators or similar equip-
ment to remove ice that has formed. They
might the insulation to be scratched.
Never use defrosting sprays. They can cre-
ate explosive gases. Do not use any electric
heating devices, open flames or ice scrap-
ers either. They might cause the insulation
to melt or to be scratched.
The door seal can be damaged by oil and
grease, which make the rubber porous and
brittle and cause the door seal to leak. Ac-
cordingly, only use clean water to clean the
door seal.
Detergents containing sand, soda or acid
are absolutely unsuitable. Universal cleaners
with a neutral pH value are recommended.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest DTL 1026 IAN 49387 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest DTL 1026 IAN 49387 in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Silvercrest DTL 1026 IAN 49387

Silvercrest DTL 1026 IAN 49387 User Manual - German, Dutch, French, Italian - 70 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info