630102
47
Zoom out
Zoom in
Previous page
1/56
Next page
Faults and what to do about them. en
47
Information on the display panel
Indicator/symbol Cause/remedy
- P - and Ï The door is unlocked. It is possible to add laundry.
- P - The temperature is too high. Wait until the temperature drops.
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary. Press the Ü button to resume the programme.
Ï is flashing Laundry may be trapped. Open and close the door again and press the Ü
button.
If necessary, push the door closed or remove the laundry and then push the
door closed again.
If necessary, switch the appliance off and on again; set the programme and
select the individual settings you require; start the programme.
Ï and the
sensoFresh î
indicator light are
flashing
The door cannot be opened due to the programme.
If the lights are off, the door can be opened.
| is lit Turn the tap on fully,
Supply hose kinked/trapped,
The water pressure is too low. Clean the filter. ~ Page 45
w The childproof lock is activated – deactivate it. ~ Page 39
o is lit Too much foam has been detected and additional wash cycles have been activated.
Add less detergent to the next wash cycle with the same load.
The indicator light for
the Drum Clean î
programme is
flashing
Run the Drum Clean î 90 °C programme or a 60 °C programme with standard
washing powder to clean and care for the drum and the outer tub.
Notes
Run the programme without laundry.
Use standard washing powder or a detergent containing bleach. To prevent
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
Switch the information signal on/off. ~ Page 42
E:18 The drain pump is blocked. Clean the drain pump. ~ Page 44
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 45
E:23 There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service. ~ Page 51
Other indicators/
symbols
Switch off the appliance, wait for five seconds and then switch it on again. If the
indicator/symbol appears again, call the after-sales service. ~ Page 51
47


Need help? Post your question in this forum.

Forumrules
1

Forum

siemens-wm16w790---iq700-sensofresh

Reset search

  • i am looking for the English translation of the instructions manual for the washing machine iq790 Submitted on 18-11-2021 at 17:42

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens WM16W790 - iQ700 sensoFresh at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens WM16W790 - iQ700 sensoFresh in the language / languages: English as an attachment in your email.

The manual is 5,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens WM16W790 - iQ700 sensoFresh

Siemens WM16W790 - iQ700 sensoFresh User Manual - Dutch - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info