652242

Siemens DH40018M Manual

12
Zoom out
Zoom in
Previous page
1/76
Next page
12
en
A fault, what to do?
Attention!
Repairs must only be carried out by an authorised technician. Improper repairs can lead to risk of serious injury to
the user.
If your appliance does not operate as required, it is often due to a very minor problem. Please check whether you can remedy
the fault yourself by using the following guidelines. You will save yourself the costs of an unnecessary visit by customer service
personnel.
Fault Cause Solution Who
Water flow-rate is too low.
The appliance does not
switch on.
The filter in either the water tap or
the showerhead is clogged.
Remove the filter and either clean it or
descale it.
Customer
The filter in the corner valve is
clogged.
Get a servicing expert to clean the
filter.
Servicing expert
The corner valve is clogged. Turn on the hot-water tap fully and
open and close the corner valve several
times. Then clean the filter in the water
tap.
Customer
The water is not sufficiently
warm.
The fuse in the house electrical
installation has tripped/blown.
Check the fuse in the fusebox. Customer
The appliance‘s automatic circuit
breaker has been tripped.
Get the appliance‘s automatic circuit
breaker checked by an electrician. Check
the permissible supply temperature.
Servicing expert
The power limit has been reached.
Water flow-rate is too high and/or
the cold water supply temperature
is too low.
Reduce the flow-rate on the tap. Customer
By a qualified professional:
use the corner valve to regulate the
flow-rate.
Check the flow-rate limiter or replace it
with a smaller one.
Servicing expert
The second stage in the appliance
does not switch on (the audible
“clicking” is missing).
Remove the filter in the tap and either
clean it or descale it.
Customer
Clean the filter in the corner valve
(Fig. A, 4.).
Servicing expert
The continuous-flow heater
switches off during the
drawing-off of water, result-
ing in a reduction in the
water temperature:
Swelling seal in the warm
water tap
A non-swelling sealing material must
be used in the warm water tap.
Customer
Winter operation:
The desired water tempera-
ture leaving the tap is no
longer reached.
The supply temperature has
reduced.
Reduce the water flow on the taps
until the desired water temperature is
reached.
Customer
If the fault could not be eliminated, please call customer service.
Disposal
This appliance is labelled in accordance with Euro-
pean Directive 2012/19/EU concerning used elec-
trical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as appli-
cable throughout the EU.
Please ask your specialist retailer about current
disposal facilities.
Guarantee
The guarantee conditions for this appliance are as defined by
our representative in the country in which it is sold.
Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim un-
der the terms of this guarantee.
Subject to change without notice.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens DH40018M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens DH40018M in the language / languages: English, German, Dutch, French, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 4,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info