628185
15
Zoom out
Zoom in
Previous page
1/19
Next page
15
3 Before use
GB
3.7 Attaching the pinpoint jet nozzle
1. Put the pinpoint jet nozzle onto the adapter so that the arrow on the
nozzle corresponds with the "unfastened" symbol of the adapter (Fig. 8/
A).
2. Fasten the pinpoint jet nozzle by turning it in the direction of the arrow
(Fig. 8/B).
- The arrow on the pinpoint jet nozzle moves towards the "fastened"
symbol.
- To unfasten the attachment, turn it in the opposite direction.
3.8 Attaching the 2in1 combi carrier
1. Put the 2in1 combi carrier onto the adapter so that the arrow on the 2in1
combi carrier corresponds to the "unfastened" symbol of the adapter
(Fig. 9/B).
2. Fasten the 2in1 combi carrier by turning it in the direction of the arrow
(Fig. 9/C).
- The arrow on the 2in1 combi carrier moves towards the "fastened"
symbol.
- The lettering meaning "top" must now actually be on top.
- To unfasten the carrier, turn it in the opposite direction.
3.9 Safety before use
AB
8
NOTE:
The pinpoint jet nozzle may only be fitted directly to the adapter (Fig. 8/
A). You may use the pinpoint jet nozzle to clean hard-to-reach places
like grooves, venetian blinds, toilet bowls, bathroom fixtures, etc.
B
C
A
-+=
This side up
9
NOTE:
The 2in1 combi attachment may only be fitted directly to the adapter
(Fig. 9/A).
It is best to use the 2in1 combi carrier covered with the cotton sheath
(Fig. 9/A) instead of the collar brush, as the cloth is able to simultaneously
pick up the condensing moisture.
1. Remove the collar brush from the the steam base.
2. Take the loop of the trapeze-shaped cotton cloth.
3. Pull the cotton cloth over the trapeze-shaped steam base in such a
way that the wide sides meet.
Never use the steam base without an attachment (cotton cloth or
collar brush) fitted, as it is not designed for such use.
WARNING:
Danger of injury! Check appliance and power cord before each use. A
damaged appliance must never be used.
ATTENTION:
Before connecting the appliance to the power supply, make sure that the
voltage stated on the type plate matches the voltage of your plug socket.
Only use sockets with a ground/safety contact.
ATTENTION:
Before starting cleaning, check whether the particular surface to be
cleaned is suitable for steam cleaning. Always follow the cleaning
recommendations of the material manufacturers. The steam cleaner is
definitely not suitable for use on uncoated wooden floors, soft plastics
and polished furniture. Cold Glass surfaces can shatter as a result of
heat shock.
NOTE:
The steam cleaner has an overheating protection device. It will switch off
automatically if overheated (e.g. due to an empty water tank). If this
happens, pull the mains plug and refill the water tank Zchapter 3.2,
„Filling the water tank“. Wait for about 45 minutes. Once the steam
cleaner has cooled down you can switch it on again.
NOTE:
Have a cotton or microfibre cloth ready for follow-up wiping. This will
absorb moisture if excess steam has been used. It will also pick up the
softened dirt.
NOTE:
Provide adequate ventilation during steam cleaning. Otherwise, the
increased humidity after cleaning could, in the worst case, cause the
formation of mould. Preferably operate the steam cleaner on warm days
when the air can absorb more moisture without shedding it as
condensation.
Shark Handdampfreiniger.book Seite 15 Montag, 14. Dezember 2009 12:04 12
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Shark M343 - hand-held steam cleaner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Shark M343 - hand-held steam cleaner in the language / languages: English, German as an attachment in your email.

The manual is 4,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info