753049
58
Zoom out
Zoom in
Previous page
1/92
Next page
Instructions for installation and use p. 14/44
5. Electrical connection
Observe Fig. 2 and Fig. 7 (gures chapter)
ATTENTION!
Damage to the unit
The sauna control unit may only be used for operating and controlling 3 heat-
ing circuits with a maximum heating capacity of 3.5 kW per heating circuit.
The maximum evaporator capacity totals 3.5 kW. Optionally with an addi-
tional power module the switching capacity can be increased from 10.5 kW
to 18 kW / 30 kW.
Please observe that in the event of a guarantee claim, a copy of the bill
from the electrician performing the work must be presented.
Work on the sauna control unit may only be performed when the power has
been disconnected.
There must be a xed connection for the electrical power supply.
An all-pole disconnecting device with full cut-off compliant with overvoltage
category III must be tted on-site.
Before installing the sauna control unit, take note of the requirements in the
installation and operation manual of the sauna heater manufacturer. The sauna
control unit has a connection area for extra-low voltage 4 and a connection
area for 230 V connections i (Fig. 2).
Observe the connection diagram (Fig. 7).
Clamp all earth conductors to the earth conductor panel d (Fig. 2).
5.1. Connecting the supply line, heater
Guide the supply and heating system lines through the installation openings e,
f (connection area for 230 V / 400 V I) into the housing lower part 1 and
connect according to the circuit diagram 7 to the terminal j with a maxi-
mum tightening torque of 1.2 Nm.
Observe the following points when connecting the power to the sauna control unit:
Installation may only be performed by a qualied electrician or similarly quali-
ed person.
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sentiotec CK 31 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sentiotec CK 31 in the language / languages: English, German as an attachment in your email.

The manual is 2,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info