Manual Scheppach LBH2600P (page 25 of 60) (English, German, Dutch, French)

781388

Zoom out

Zoom in

1/60

25GB

• Align the rst blower tube compartment (3) with the

protrusion (4) of the air outlet, push the tube and

turn it 90° clockwise, in order to permanently x it

in place.

• Fix the tube (3) to the air outlet using the screw (1)

and its washers (2).

• Align the second blower tube compartment (5) with

the protrusion (6) of the rst tube, push the tube

and turn it 90° clockwise, in order to permanently

x it in place.

NOTE The machine is correctly assembled when the

at part of the blower chute is pointed towards the

ground. The engine can not start if you do not as-

semble the blower tube when using as a blower.

USE AS A VACUUM COLLECTOR

• Remove the screw (1) and its washers (2).

• Align the housing of the bag tube (3) with the pro-

trusion (4) of the air outlet, push the tube and turn

it 90° anticlockwise, in order to permanently x it

in place.

The machine is correctly assembled when the tube’s

terminal chute is pointed downwards and to the left of

the operator

• Fix the tube (3) to the air outlet using the screw (1)

and its washers (2).

• Loosen the knob (5) and open the protection grille

(6).

• Align the rst vacuum tube compartment (7) with

the protrusion (8) of the inlet, push the tube and

turn it 90° clockwise, in order to permanently x it

in place.

• Align the second vacuum tube compartment (9)

with the protrusion (10) of the rst tube, push the

tube and turn it 90° clockwise, in order to perma-

nently x it in place.

The machine is correctly assembled when the round-

ed part of the chute is pointed towards the ground.

• Insert the bag tube end (3) in to the bag (11) and

close the opening with the supplied Velcro strap

(12).

• Hang the bag over your shoulder and adjust the

height using the strap.

The engine can not start if you do not assemble

the vacuum tube when using as a vacuum.

PREPARING TO WORK

CHECKING THE MACHINE

Before starting work please:

• check that all the screws on the machine are tightly

fastened;

• when used as a vacuum collector, make sure the

bag is tted correctly and that the zip is closed;

• check that the air lter is clean;

• check that the hand grips are well fastened;

• prepare accessories according to the type of work

(as blower or vacuum collector) and make sure

they are correctly mounted;

• ll with fuel as indicated below.

Start (Fig 6)

Once the machine has been set up properly, start

the engine as follow:

1 Turn the engine switch(1) to the ON position (E).

2 Put the choke lever(11) on the position .

3 Press the fuel pump(10) more than 5 times(G).

4 Pull the recoil starter handle (8) 3-5 times to start

the engine.

5 Once the motor is running, briey wait, then put

the choke lever(11) into position.

6 If there are problems, immediately turn the motor

switch (1) to “0” so the motor stops.

7 If the motor is warm, you can leave the choke le-

ver(11) in the “warm start and work” position.

Note: If the engine does not start up even after sever-

al attempts, read the section „Engine troubleshooting“.

Note: Always pull the starter cord out in a straight

line. If it is pulled out at an angle, then friction will

occur on the eyelet. As a result of this friction, the

cable will become frayed and will wear away faster.

Always hold the starter handle when the cable re-

tracts. Never allow the cable to snap back when it

has been pulled out.

OPERATING MODES

USE AS A BLOWER

Warning: The machine must always be rmly gripped

with your right hand on the upper hand grip during

work.

The engine speed should be adjusted to the type of

material to be removed:

• use the engine at low speed for lightweight mate-

rial on the lawn;

• use the engine at average speed to move grass and

lightweight leaves on pavement or solid ground;

• use the engine at high speed for heavier materials

like fresh snow or voluminous dirt.

Warning: Always pay the utmost attention to prevent

removed material or dust from injuring people or ani-

mals or damaging property. Always assess the wind

direction and never work against the wind.

USE AS A VACUUM COLLECTOR

Warning: The machine must always be rmly held

with both hands during work. Place your left hand

on the upper hand grip and your right hand on the

lower hand grip so that the bag is on the right-hand

side of the operator.

When used as a vacuum collector, it is best to use

the engine at average/high speed. During collection,

keep the rounded end of the tube a few centimetres

o󰀨 the ground. The bag also works as a lter similar

to a common home vacuum.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach LBH2600P in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3.31 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach LBH2600P Manual

Product: