782035
23
Zoom out
Zoom in
Previous page
1/104
Next page
23GB
6. Technical data
HTH250/240P
Technical data
Cutting data Hedge Trimmer
Engine Type 2 - stroke engine - air cooled
Capacity cm325,4
Engine power kW 0,7
Idle speed n0/min-1 3400
Max. Engine speed min-1 9500
Fuel tank capacity l 0,6
Mixing ratio (fuel / two-stroke oil) 40:1
Cutting length mm 600
Max. cutting thickness mm 27
Dimension L/B/H mm 1165/230/220
Sword length mm 690
Weight kg 5,9
Subject to technical changes!
Information concerning noise emission measured ac-
cording to relevant standards:
Sound pressure LpA = 96 dB(A)
Sound power LWA = 108 dB(A)
Uncertainty KpA = 3 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Vibration (real handle) Ahv = 6,9 m/s2
Uncertainty Khv = 1,5 m/s2
7. Before starting the equipment
The hedge trimmer is supplied without fuel.
Fuel the hedge trimmer as described under “Fuelling”.
Fuelling
This device is operated by a mixture from regular pet-
rol (unleaded) and two-stroke engine oil.
Utmost care is required when handling fuel and oil.
Keep away smoke and open ames (risk of explo-
sion).
Petrol
Petrol: Octane number at least 91 ROZ unleaded
Do not ll in leaded petrol, diesel or other non-ap-
proved fuels.
Do not use petrol having a smaller octance number
than 91 ROZ. This may lead to severe engine dam-
ages due to increased engine temperatures.
If you frequently operate the device at high speeds,
you should use petrol with a higher octane number.
The use of unleaded petrol is recommended for envi-
ronment protection reasons.
Two-stroke engine oil:
acc. to JASO FC or ISO EGD specications
Do not use
- four-stroke oil or two-stroke oil for water-cooled out-
board engines,
- mixtures ready for use from petrol stations.
Mixing
Ratio of mixture: 40:1
Petrol Two-stroke engine oil 2,5% (40:1)
1 litres 0.025 litres
2 litres 0.05 litres
5 litres 0.125 litres
10 litres 0.25 litres
Measure the oil quantity accurately as a small devia-
tion of it has a large effect on the ratio of mixture in
particular for small fuel quantities.
Do not change the ratio of mixture. This will lead to
more residues of combustion, a higher fuel consump-
tion, a decrease of output or damages to the engine.
Mix petrol and oil in a clean container approved for pet-
rol and appropriately identied. Use a fuel container
with overll protection.
1. At rst ll in half the quantity of petrol to be mixed.
2. Then ll in the total amount of oil.
3. Shake the fuel mixture.
4. Fill in the remaining quantity of petrol.
Fuels have only a limited shelf-life, they are subject to
ageing. Outdated fuels and fuel mixtures may result in
starting problems. Therefore, mix only that quantity of
fuel which you can use within a month. Only store fuels
in containers approved and identied for this. Keep fuel
containers in a dry and safe area.
Make sure that fuel containers are kept out of the
reach for children.
Caution! Prior to starting the machine learn how to put it
out of action in emergency cases.
Fuelling the hedge trimmer
Stop the engine and allow it to cool down.
Wear protective gloves.
Avoid eye and skin contact.
Strictly follow the instructions under “Safe handling
with fuels”.
1. Only fuel the hedge trimmer in the open or in suf-
ciently ventilated rooms.
2. Clean the area around the ller neck. Contamina-
tion in the tank may result in malfunction.
3. Shake the container once more before pouring the
fuel mixture into the tank.
4. Carefully open the tank cap (10) to allow possible
overpressure to relax.
5. Carefully ll the fuel mixture up to the lower edge
of the ller neck.
6. Close the tank cap. Check that the tank cap is
tight.
7. Clean the tank cap and the area around it.
8. Check the tank and the fuel lines for leaks.
9. Operate the fuel pump (11) if required.
10. Before starting the engine go away at least three
metres from the fuelling place.
8. Attachment and operation
You may not start to operate the machine until you have
read these operating instructions, observed all the in-
structions given and completely and properly assem-
bled the machine!
- Make sure that the ON/OFF switch (6), the throttle
lock-out switch (7) and the throttle trigger (14) func-
tion perfectly.
- This hedge trimmer is only allowed to be started after
it is completely assembled.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach HTH250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach HTH250 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish as an attachment in your email.

The manual is 4.41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info