Manual Scheppach HP2200S (page 28 of 148) (English, German, French, Italian, Polish)

781866

Zoom out

Zoom in

1/148

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58  www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

28 | GB

The operator must never stand in the direction of de-

scent.

The max. gradient of 25° must not be exceeded.

m ATTENTION!

If this gradient were exceeded, this would result in

a failure of the engine lubrication system (splash lu-

brication and thus inevitably lead to a breakdown of

important engine components.

Stopping engine

To stop the engine in an emergency, simply turn the

engine switch (17) to the OFF position. Under normal

conditions, use the following procedure.

• To stop the compactor from traveling, return the en-

gine throttle lever (1) to idle position.

• Allow engine to cool down for one or two minutes

before stopping.

• Turn the engine switch (17) to ‘‘OFF” position.

• Turn off the fuel valve (11) where applicable.

m ATTENTION!

Do not move choke control (10) to CLOSE

to stop engine. Backre or engine damage may oc-

cur.

Idle speed

Set throttle control lever (1) to its SLOW

position to reduce stress on the engine when com-

pacting is not being performed.

Lowering the engine speed to idle the engine will help

extend the life of the engine, as well as conserve fuel

and reduce the noise level of the machine.

11. Cleaning

m ATTENTION!

Always shut the engine down and remove the spark

plug connector before carrying out any cleaning work.

We recommend that you clean the device directly af-

ter every use.

Remove all debris from the plate compactor with a

soft brush, vacuum, or compressed air.

Clean the bottom of the compactor base as soon as it

begins to pick up soil being compacted. The unit can

not do a good job if the bottom surface is not smooth

and clean.

Clean the device at regular intervals using a damp

cloth and a little soft soap. Do not use any cleaning

products or solvents; they could attack the plastic

parts of the device. Make sure that no water can pen-

etrate the device interior.

langsam schnell

vitesse lente vitesse rapide

slow fast

Pomalu rychle

Pomalý rýchly

Počasnega hitrega

lassú gyors

бавно бързо

Nopea hidas

langsam schnell

vitesse lente vitesse rapide

slow fast

Pomalu rychle

Pomalý rýchly

Počasnega hitrega

lassú gyors

бавно бързо

Nopea hidas

Starting engine (g. I + K)

• Move the fuel valve lever (11) to the ON position.

To start a cold engine, move the choke (10) to the

CLOSE position

• If the choke lever (10) has been moved to the

CLOSE position to start the engine, gradual-

ly move it to the OPEN position as the engine

warms up.

• To restart a warm engine, leave the choke lever (10)

in the OPEN position.

• Turn the engine switch (17) to the ON position.

• Operate the recoil starter (14).

Recoil starter (5), (g. A)

Pull the starter grip (14) lightly until you feel resistance,

then pull briskly, return the starter grip (14) gently. If the

choke lever (10) has been moved to the CLOSE posi-

tion to start the engine, gradually move it to the OPEN

position as the engine warms up. After engine

warms up, pull throttle lever (1) to accelerate engine

speed. Plate will begin vibrating and proceed with

compacting.

Forward motion

The plate compactor moves forwards automatically

when the throttle is opened fully.

m ATTENTION!

Do not operate plate on concrete or on extremely

hard, dry, compacted surfaces. The plate will jump

rather than vibrate and could damage both plate and

engine.

The number of passes required to reach a desired

compaction level will depend on the type and mois-

ture content of soil. Maximum soil compaction has

been reached when excessive kickback is noticed.

When using plate on paving stones, attach a rubber

pad (c) to the bottom of the plate to prevent chipping

or grinding surface of the stones.

While a certain amount of moisture in the soil is nec-

essary, excessive moisture may cause soil particles

to stick together and prevent good compaction. If

soil is extremely wet, allow it to dry somewhat before

compacting.

If soil is so dry as to create dust clouds while oper-

ating plate, some moisture should be added to the

ground material to improve compacting. This will also

reduce service to the air lter.

The following points are to be observed when com-

pacting on sloped surfaces (slopes, embankments):

Only approach gradients from the bottom (a gradient

which can be easily overcome upwards can also be

compacted downwards without any risk).

IM_5904612903_HP2200s_191212_new.indd 28IM_5904612903_HP2200s_191212_new.indd 28 12.12.2019 07:40:2012.12.2019 07:40:20

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach HP2200S in the language / languages: English, German, French, Italian, Polish as an attachment in your email.

The manual is 12.1 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach HP2200S Manual

Product: