Manual Scheppach HP2200S (page 27 of 148) (English, German, French, Italian, Polish)

781866

Zoom out

Zoom in

1/148

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58  www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

GB | 27

Lift Point (3), (g. A

Used to lift the machine with crane or other lifting de-

vice.

Belt Guard (19), (g. A)

Remove this guard (19) to gain access to the V-belt.

Never run the compactor without the V-belt guard

(19).

If the V-belt guard (19) is not installed, the possibili-

ty exists that your hand may get caught between the

V-belt and clutch, thus causing serious injury and

bodily harm.

Exciter (5), (g. A)

An eccentric weight mounted on the exciter shaft con-

tained within exciter housing is driven at high speed

by a clutch and belt drive system. This high speed

shaft revolution causes the rapid lifting and down-

ward ramming motion of the machine as well as im-

parting a forward motion.

Engine switch (On-Off) (17), (g. A + I)

The engine switch (17) enables and disables the igni-

tion system. The engine switch (17) must be in the ON

position for the engine to run.

Turning the engine switch (17) to the OFF position

stops the engine.

Check before operation

Check

• Look around and underneath the engine for signs

of oil or gasoline leaks.

• Look for signs of damage.

• Check that all shields and covers are in place, and

all nuts, bolts, and screws are tightened.

Checking the engine oil (g. I -R)

• Take the oil dipstick (16) and clean.

• Insert the oil dipstick (16) in and check the oil lever

without screwing down.

• If the oil is too low, add the recommenced oil in.

• After nishing, reassemble and screw the oil dip-

stick (16) down.

Check fuel (g.S)

• First stop the engine, open the fuel cover (12), and

check oil level. If the oil level is too low, add the fuel

to full, after nishing, screw the fuel cover down.

• Don’t add the fuel over the shoulder of the carburet-

tor when fueling (maximum oil level).

• Recommended octane rating over 90 unleaded

gasoline For unleaded gasoline, can make carbon

deposit muck less and enhance exhaust system

service life.

• Don’t use used and contaminated or gasoline with

oil , Avoid the dirt and water entering into fuel tank.

m ATTENTION!

The compactor is not intended to be used on co-

hesive soils such clay or hard surfaces like con-

crete.

The equipment is to be used only for its prescribed

purpose. Any other use is deemed to be a case of

misuse. The user / operator and not the manufacturer

will be liable for any damage or injuries of any kind

caused as a result of this.

An element of the intended use is also the obser-

vance of the safety instructions, as well as the as-

sembly instructions and operating information in the

operating manual.

All persons who use and service the equipment have

to be acquainted with this manual and must be in-

formed about the equipment’s potential hazards. It is

also imperative to observe the accident prevention

regulations in force in your area. The same applies

for the general rules of health and safety at work.

The manufacturer will not be liable for any changes

made to the equipment nor for any damage resulting

from such changes.

The machine shall be operated only with original

parts and original accessories from the manufacturer.

The safety, operating and maintenance specications

of the manufacturer, as well as the dimensions speci-

ed in the technical data, must be observed.

Please note that our equipment has not been de-

signed for use in commercial, trade or industrial appli-

cations. Our warranty will be voided if the equipment

is used in commercial, trade or industrial businesses

or for equivalent purposes.

10. Installation

m ATTENTION!

Always make sure the device is fully assembled

before start-up!

Hand Grip (2), (g. A)

When operating the compactor, use this hand grip (2)

to maneuver the compactor.

Throttle Control (1), (g. A + C)

The throttle lever (1) controls engine speed. Moving

the throttle lever (1) in the directions shown makes

the engine run faster or slower.

fast =

slow =

langsam schnell

vitesse lente vitesse rapide

slow fast

Pomalu rychle

Pomalý rýchly

Počasnega hitrega

lassú gyors

бавно бързо

Nopea hidas

langsam schnell

vitesse lente vitesse rapide

slow fast

Pomalu rychle

Pomalý rýchly

Počasnega hitrega

lassú gyors

бавно бързо

Nopea hidas

IM_5904612903_HP2200s_191212_new.indd 27IM_5904612903_HP2200s_191212_new.indd 27 12.12.2019 07:40:2012.12.2019 07:40:20

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach HP2200S in the language / languages: English, German, French, Italian, Polish as an attachment in your email.

The manual is 12.1 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach HP2200S Manual

Product: