781462
36
Zoom out
Zoom in
Previous page
1/112
Next page
www.scheppach.com
36 | GB
15. Troubleshooting
WARNING
Always switch the machine o󰀨 and remove the mains plug prior to all maintenance and cleaning work.
Fault Possible cause Remedy
Saw blade without
pins loosens after
switching o󰀨 the
engine
Saw blade clamping screw (28/29) not tightened
enough
Tighten the saw blade clamping
screw (28/29)
Motor does not start Failure mains fuse Check the mains fuse.
Extension cable defect Change extension cable.
Fine-wire fuse defective Check the ne-wire fuse and, if
necessary, replace it with a ne-wire
fuse of the same type.
Connections on the motor or switch defect Have it checked by an electrician.
Motor or switch defect Have it checked by an electrician.
Saw blades brake Tension set incorrectly Set correct tension
Load too high Feed workpiece more slowly
Incorrect saw blade type Use correct saw blades
Workpiece not fed straightly Avoid lateral pressure
Saw blade oscillates,
not aligned straightly.
Holders not aligned Open the screws that fasten the hold-
ers. Bring the holders into the vertical
position and tighten the screws again.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach DECO-XLS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach DECO-XLS in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info