629722
68
Zoom out
Zoom in
Previous page
1/93
Next page
66 VERSA IP SATEL
LCD keypad
You can enable/disable the presence control option:
immediately after adding a detector to the system (for the procedure of adding 433 MHz
wireless detectors, refer to the INSTALLER MANUAL),
using the CONFIG.DEVICE function (SERVICE MODE 2. HARDWARE 1. KPDS & EXPS
3. WIRELESS DEV. 2. CONFIG.DEVICE). Having started the function, use the and
keys to select the zone to which the wireless detector is assigned and press .
To enable/disable the option, press any numeric key ( – option disabled, – option
enabled), and then press .
9.5.3 433 MHz wireless detectors and zone programming
When programming the zones to which 433 MHz wireless detectors are assigned, take into
consideration the specific character of the operation of such detectors. The wireless
detectors send information on violations, tampers and low battery status. The information on
violations and tampers is sent to the zone to which the detectors are assigned. These zones
can be programmed as:
NC, NO or EOL – the zone will inform about detector violation,
2EOL/NC or 2EOL/NO – the zone will inform about detector violation and tamper.
The information on tamper and tamper restore is sent by the detector in real time.
How information about violation is sent depends on the detector operating mode:
normal – the detector sends information on violation and violation restore in real time (the
zone status corresponds to the detector status),
energy save (available in some detectors) – after sending information on violation, the
detector will not send any further information about violations for 3 minutes (the zone will
be violated for 2 seconds after the controller receives the transmission containing
information on detector violation).
9.6 Proximity card arm/disarm device
Fig. 19. DLOADX program: configuring the proximity card arm/disarm device.
LED R – reaction of the partition after removal of the card from the device, when the red LED
is lit. The partition can be fully armed or its status may remain unchanged.
LED G / LED Y – reaction of the partition after removal of the card from the device, when the
green / yellow LED is lit. The partition can be armed in one of three modes, it can be
disarmed or its status can remain unchanged.
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel Versa IP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel Versa IP in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel Versa IP

Satel Versa IP Quick start guide - English - 11 pages

Satel Versa IP User Manual - English - 32 pages

Satel Versa IP Installation Guide - English - 36 pages

Satel Versa IP User Manual - English - 43 pages

Satel Versa IP Quick start guide - German - 11 pages

Satel Versa IP Additional guide - German - 97 pages

Satel Versa IP User Manual - German - 45 pages

Satel Versa IP Installation Guide - German - 38 pages

Satel Versa IP Quick start guide - Dutch - 2 pages

Satel Versa IP User Manual - Dutch - 45 pages

Satel Versa IP Quick start guide - Dutch - 12 pages

Satel Versa IP Additional guide - Dutch - 93 pages

Satel Versa IP User Manual - Dutch - 45 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info