699548
19
Zoom out
Zoom in
Previous page
1/52
Next page
SATEL MICRA 17
Power 12V DC – enabling this option will result in switching off the built-in power supply,
its control system, and in disconnecting the battery. In order to connect and external
power source to the device, connect the common ground to the COM terminal on the
module electronics board, and 12 V DC voltage to the AUX terminal.
If the “Power 12V DC” option is enabled, do not connect battery to the module.
Entry delay – parameter available in the alarm device mode, denoting the time by which
the alarm will be delayed when an armed zone of the 4. D
ELAY
type is violated. It
enables the zone to be disarmed before an alarm is triggered. You can program up to
255 seconds. If value 0 is programmed, violation of the armed 4. D
ELAY
zone type will
trigger an instant alarm.
Exit delay – parameter available in the alarm device mode, denoting the time counted
from the moment of arming. Violation of a 0. I
NSTANT
or 4. D
ELAY
zone type during the
exit delay countdown will trigger no alarm, which allows you to leave the protected area
without setting off alarm. You can program up to 255 seconds. If value 0 is
programmed, all zones will be instantly armed.
AC loss report delay – the time during which the module AC power must be lost for
a trouble to be reported. The trouble report delay prevents momentary outages, which
do not affect the normal operation of the module, from being reported. You can program
up to 99 minutes and 99 seconds.
Zones
Working parameters for hardwired and wireless zones are programmed in separate tables.
Wired zones
Name – individual name of zone (up to 16 characters).
Type – you can program the following wiring types (you can make your selection in the
right-click drop-down menu, or by entering a digit corresponding to the wiring type):
0. disabled – select this type, if no device is connected to the zone;
1. NC – select this type, if a device with normally closed contacts is connected to the
zone;
2. NO – select this type, if a device with normally open contacts is connected to the
zone;
3. – depending on the operating mode:
communication device: 3. analog – select this type, if the zone is to supervised
analog signals;
alarm device: 3. EOL 2k2 – select this type, if a 2.2 k EOL resistor is used.
Sensitivity – time during which:
the NC type zone must be disconnected from the ground so that the module can
register the zone violation,
the NO type zone must be shorted to ground so that the module can register the
zone violation,
the EOL type zone must be shorted to ground or disconnected from the ground so
that the module can register the zone violation,
voltage on the analog zone must drop below threshold L (minus tolerance) or rise
above threshold H (plus tolerance) so that the module can register exceeding the
preset value (see Fig. 10).
Values from the 0 to 5100 ms range can be programmed (every 20 ms).
Restore – time during which:
the NC type digital zone must be again shorted to ground so that the module can
register zone restore,
19


Need help? Post your question in this forum.

Forumrules
1

Forum

satel-micra

Reset search

  • I want to write a name for the Urmet 1784 model, is there a link? Submitted on 30-5-2022 at 16:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel MICRA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel MICRA in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel MICRA

Satel MICRA User Manual - German - 52 pages

Satel MICRA User Manual - Dutch - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info