699608
6
Zoom out
Zoom in
Previous page
1/15
Next page
4 SATEL CA-4v1
Connection of detectors
Detector wires should be connected to
proper terminals on the main board. The
way of connection 2.2k EOL resistor
shown on the scheme. For powering the
detectors is intended to be used the
AUX output. TMP terminals should be
connected to a tamper circuit.
Connection of signaling devices
The signaling devices should be
connected to OUT1 and OUT2 outputs.
In the devices the 2.2k resistors should
be connected in parallel to enable the
panel to control the signaling devices
wiring. If few signaling devices are
connected parallel to one output, the
resistor should be mounted in the
furthest signaling device from the control
panel.
Caution:
The signaling devices wires control cannot replace an tampering circuit which
should be used to protect them.
The OUT1 and OUT2 outputs control the ground terminal. The +12V voltage is led
through F2 and F3 fuses to +OUT1 and +OUT2 terminals. The -OUT1 and -OUT2
terminals are cut off in inactive state, in active state (alarm signaling) they are shorted
to ground (0V).
After all the parts are carefully and properly connected the system can be power up. It is
recommended to start the alarm system only with power supply, without a battery connected.
Figure 4. Connection of the signaling device
AC AC AUX +OUT1- +OUT2- COM CLK DATA +KEY Z1 COM Z2 Z3 COM Z4
Control panel CA-4v1
+ SO - + SA - SAB
Signaling device
SPL-2010
to a tamper circuit
Figure 3. Connection of the detectors
NC NC TMP TMP COM 12V
Connection of a NC detector (AQUA)
zones Z1
Z4
COM
detector power supply (AUX)
2.
2K
COM
+12V NO C TMP TMP COM
Connection of a NO detector
zones Z1
Z4
COM
detector power supply (AUX)
2.
2K
COM
tamper circuit
tamper circuit
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel CA-4v1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel CA-4v1 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info