699577
15
Zoom out
Zoom in
Previous page
1/24
Next page
CA-10 SATEL
13
9 - telephone line loss - the message indicates that the telephone line is cut off. It
may also indicate lifting the receiver of a telephone connected to the
same line for longer than the time specified by the installer.
10 - problem with transmission to monitoring station – the control panel
cannot get connected to the monitoring station, or the station fails to
confirm receiving of the monitoring codes,
11 - telephone line trouble - informs that the telephone messaging has failed
(no dialing tone when the receiver is off-hook; interrupted signal instead
of continuous one; busy line).
The troubles 10 and 11 will be signaled until next successful telephone
connection. The condition can be cleared by calling the trouble check-
out function and pressing the [#] key.
12 - output 4 trouble
ALL OFF - system memory error - the message appears in case of erratic
microchip operation of the system (it may be caused by strong
electromagnetic interference e.g. produced by lightning) - in most cases
service should be called.
Pressing any key stops the function. If the installer has enabled the audible trouble
signaling, activating the trouble check-out function turns the signaling off.
Switching CHIME on/off [8]
The function makes it possible for the user to switch the chime (audible signaling of the
violation of specified detectors) on/off in the keypad. Three short beeps in the keypad
confirm switching off of the chime signaling. Four short and one long beeps confirm
switching the chime on.
The installer decides which zones and in which keypads can use chime to signal their
status.
Keypad backlighting [9]
The function, which is only available in the CA-10 KLED-S keypads irrespective of the
installer's settings, is used to control the keypad backlighting.
After restarting the system (power-up), the keypad always enters the automatic
backlighting mode, which is activated by pressing any key. To change the backlighting
mode, press the numeric key 9 and hold it down until you hear the corresponding signal.
One beep - no backlighting.
Two beeps - automatic backlighting.
Three beeps - continuous backlighting.
Fire alarm [
*
]
This function activates the fire alarm from the keypad.
Auxiliary alarm [0]
The purpose of this alarm depends on current needs. It may be, for instance, an
emergency call for medical assistance. The function may transmit an appropriate
message about auxiliary alarm to the monitoring station and activate telephone
messaging.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel CA-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel CA-10 in the language / languages: English as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel CA-10

Satel CA-10 User Manual - English - 2 pages

Satel CA-10 User Manual - English - 2 pages

Satel CA-10 User Manual - English - 2 pages

Satel CA-10 Additional guide - English - 60 pages

Satel CA-10 Additional guide - English - 24 pages

Satel CA-10 Quick start guide - English - 11 pages

Satel CA-10 Installation Guide - English - 43 pages

Satel CA-10 User Manual - German - 2 pages

Satel CA-10 User Manual - German - 4 pages

Satel CA-10 Additional guide - German - 64 pages

Satel CA-10 Additional guide - German - 24 pages

Satel CA-10 User Manual - German - 26 pages

Satel CA-10 Installation Guide - German - 44 pages

Satel CA-10 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info