681498

Sanitas SIH 21 Manual

20
Zoom out
Zoom in
Previous page
1/64
Next page
20
6. End of inhalation
If the spray is only output sporadically or if the noise
changes during inhalation, you can end the treatment.
• Switch off the nebuliser after treatment using the on/
off switch [3] and disconnect it from the mains.
•
After use, replace the atomiser [9] in its holder [7].
7. Clean the device
For information about this, see “Cleaning and disinfec-
tion” on page 20.
7. Changing the filter
In normal operating conditions, the air filter must be
replaced after approx. 500 operating hours or one year.
Please check the air filter regularly (after 10-12 nebuli-
sation procedures).
If the filter is very contaminated or blocked, replace the
used filter. If the filter has become wet, it must also be
replaced with a new one.
Caution
•
Do not try to clean and re-use the used filter!
•
Only use original filters supplied by the manufacturer.
Otherwise, your nebuliser may become damaged or
effective therapy can no longer be guaranteed.
•
Do not repair or maintain the air filter while it is in use.
•
Never operate the device without a filter.
To replace the filter, proceed as follows:
Caution
•
First switch off the unit and unplug it.
•
Allow the unit to cool down.
1. Remove filter cap [5] upwards.
Note
If the filter remains in the unit when the cap is removed,
remove the filter from the unit using tweezers or similar.
2. Replace the filter cap [5] containing the new filter.
3. Check that the filter cap is firmly in place.
8. Cleaning and disinfection
Atomiser and accessories
Warning
Observe the following hygiene instructions in order to
avoid any health risks.
•
The atomiser [9] and accessories are intended for
multiple use. Please note that cleaning requirements
differ according to the different application areas.
Notes:
•
The atomiser and accessories must not be mechan-
ically cleaned with brushes or similar as this can
cause irreparable damage and the success of the
treatment can no longer be guaranteed.
•
For additional requirements regarding the necessary
hygienic preparations (hand washing, handling of
medicines or inhalation solutions) in high-risk groups
(e.g. cystic fibrosis patients), contact your doctor.
•
Ensure that all parts are properly dried following all
cleaning and disinfection. Residual moisture or water
droplets can result in an increased risk of bacterial
growth.
Preparation
•
Directly following each treatment, all parts of the
atomiser [9] and any accessories used must be
cleaned of medicine residues and contamination.
•
To do this, dismantle the atomiser [9] into its com-
ponent parts.
•
Remove the mouthpiece [12] from the atomiser.
•
Dismantle the atomiser by twisting the upper section
anti-clockwise against the medicine container [11].
•
Remove the nozzle attachment [10] from the medi-
cine container [11].
•
The nebuliser is later reassembled in the reverse
order.
Cleaning
Important
Before you clean the unit, always switch it off, unplug
it and let it cool off.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanitas SIH 21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanitas SIH 21 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 1,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info