Manual Sanitas SIH 21 (page 22 of 64) (English, German, French, Italian)

681498

Zoom out

Zoom in

1/64

9. Disposal

In the interest of environmental protection, do not dis-

pose of the device in household waste.

Please dispose of the device in accordance wi

th EC Directive – WEEE (Waste Electrical and

Electronic Equipment).

If you have any queries, please contact the ap

prpriate local authorities.

10. Troubleshooting

Problem/Question Possible Cause/Remedy

The atomiser produces

little or no aerosol.

1. Too much or too little medicine in the atomiser.

Minimum: 2 ml, Maximum: 8 ml.

2. Check that the nozzles are not blocked If necessary, clean the nozzle (e.g.

by rinsing). Use the atomiser again.

CAUTION: Only poke implements through the fine holes from the underside

of the nozzle.

3. The atomiser is not held in an upright position.

4. The medicine solution is unsuitable for nebulising (e.g. too thick). The

medicine solution should be specified by the doctor.

Output is too low. Hose kinked, filter blocked, too much inhalation solution.

Which medicines are suitable

for inhalation?

Consult your doctor.

Essentially all medicines that are suitable and approved for device-based

inhalation can be inhaled.

Some inhalation solution

remains in the atomiser.

This is normal and occurs for technical reasons. Stop inhalation if you hear a

notable difference in the noise of the atomiser.

What special steps should

be taken for babies and

children?

1. In babies, the mask should cover the mouth and nose to guarantee effec

tive inhalation.

2. In children, the mask should also cover the mouth and nose. Nebulisation

next to a sleeping person is not suitable because insufficient medicine

reaches the lungs.

Note: Children should only use the device with help and under supervision

of an adult. Never leave a child alone with the nebuliser.

Inhalation with the mask

takes longer.

This is for technical reasons. Less medicine is inhaled per breath through

the mask holes than using the mouthpiece. The aerosol is mixed with ambi

ent air through the holes in the mask.

Why do I need to replace the

atomiser at regular intervals?

There are two reasons for this:

1. To guarantee a therapeutically effective particle spectrum, the nozzle

holes should not exceed a certain diameter. Due to the thermal and

mechanical stresses, the plastic is subjected to a certain amount of wear.

The nozzle attachment [10] is particularly susceptible to this wear. This

can also cause changes to the droplet composition of the

aerosol, which

has a direct effect on the effectiveness of the treatment.

2. You are also recommended to replace the atomiser on a regular basis for

hygiene reasons.

Does each person need their

own atomiser?

This is absolutely necessary for hygiene reasons.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sanitas SIH 21 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 1,73 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sanitas SIH 21 Manual

Product: