647727

Salter BPA-9200 Manual

8
Zoom out
Zoom in
Previous page
1/16
Next page
GB
8
d. The monitor inflates the cu until sucient pressure has built up for a measurement. Then the monitor slowly releases
air from the cu and carries out the measurement. Finally the blood pressure and pulse rate will be calculated and
displayed on the LCD screen separately. Irregular heartbeat symbol (if any) will blink. See picture 6-4 & 6-5. The result
will be automatically stored in the current memory bank.
Picture 6-3 Picture 6-4 Picture 6-5
e. After measurement, the monitor will turn o automatically after 1 minute of no operation. Alternatively, you can press
the “START” button to turn o the monitor manually.
f. During measurement, you can press the “START” button to turn o the monitor manually.
Note: Please consult a health care professional for interpretation of pressure measurements.
7. DISPLAYING STORED RESULTS
a. After the measurement, you can review the measurements in the current memory bank by pressing button “MEM”. Now
the LCD displays the amount of the results in the current bank. See picture 7.
Picture 7 Picture 7-1 Picture 7-2
b. Alternatively, press “MEM” button in Clock Mode to display the stored results. The current memory bank will blink and
the amount of results in this bank will be displayed. See picture 7-1. Press “START” button to change over to other bank.
See picture 7-2. Confirm your selection by pressing “MEM” button. The current bank can also be confirmed automatically
after 5 seconds with no operation.
c. After selecting the memory bank, the LCD will display the average value of the last three results in this bank, See picture
7-3 &7-4. If no result stored, LCD will show dashes as picture 7-5.
Picture 7-3 Picture 7-4 Picture 7-5
… 8 …


Need help? Post your question in this forum.

Forumrules
1

Forum

salter-bpa-9200

Reset search

  • is it possible to replace the salter monitor cuff model BPA-9200-GB and how much would that cost ?

    I keep getting Er 4 whenever I try to use it.. I have used it looser before without being told the problem is that I do not tighten it enough on my arm . Any advice please?
    Thank you Abbas Baba Submitted on 27-4-2021 at 16:45

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Salter BPA-9200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Salter BPA-9200 in the language / languages: English as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info