8
– So that your battery is always ready-to-operate, we recommend you always charge
the battery for approx. 24 hours prior to and after each mowing season. Avoid total
discharges since this may result in a battery failure.
– To prevent unauthorised use of the mower, especially by children, always remove
the ignition key and disconnect the cable which leads from the battery t
motor by removing the battery plug from the mating plug of the cable harness
when you store the lawn mower until the next mowing. However, you should do
this at least before you store the mower for the winter break.
– Store the battery in a dry, cool and frost-protected room.
Pos: 16.9 /Inne1
NOTE
The battery can be charged in the assembled or disassembled state.
Pos: 16.10 /In 2 @ 1
Charger (Illustration R4 )
Pos: 16.11 /
The charger is made up of two parts and must be put together before initial use.
Insert the country-
into place.
IMPORTANT
Use the charger supplied only for charging the r
Equally, do not try to charge your
endanger yourself or damage your
For safety reasons and to avoid damage to the charger, it may only be used
indoors and in dry rooms and the batter
Chafed or bent connection cables on the plug-charger can l
cable load. Chargers with damaged cables must be r
Pos: 16.12 /doc
Charging in assembled stat
Pos: 16.13 /In @ 1
– Remove the battery cable from the cable harness.
– Connect the battery cable to the original charging device and plug the charging
device into a 230 V socket.
Pos: 16.14 /Indocx @ 5839
Charging the battery in disass
Pos: 16.15 /In.docx @ 1
Removing the battery
– To remove the battery, detach the cable f
nuts.
– Turn the battery with the battery lid by 90° to the front and remove upwards.
– Connect the battery cable to the original charger and plug the charger into a socket
with 230 V.
Pos: 16.16 /In
IMPORTANT
Please do not connect the charger to the plug connector of the cable har
since this can lead to a fault in the charger.
Pos: 16.17 /.
NOTE
The red warning light on the charger
goes out after charging has finished.
Pos: 16.18 /In @
– After charging the battery, refasten to the battery holder (if the battery was
dismounted for charging). Reconnect the battery cable to the cable harness prior
to mowing.
Pos: 16.19 /In@ @ 1
NOTE
As soon as the battery must be renewed for reasons of age or mechanical
damage, it should be handed in as hazar
your community or your authorized deal
Pos: 16.20 /2 @ 1
Filling with oil (Illustration
Pos: 16.21 /
Safety instruction!
See table for explanation of symbols page 3
Pos: 16.22 /@ 1
IMPORTANT
Avoid damage! Engine is delivered wi
the engine.
Pos: 16.23 /0
Before starting the engine for the first time, use a funnel to fill motor oil (quantity and
quality see technical data) having unscrewed the dipstick in this opening first
– Set the mower on level ground.
– Slowly fill oil through the filler neck. Do not overfilr filling the oil, wait for about
one minute and then check the oil level.
Insert the dipstick and screw it tight.
– Check oil level
Remove the dipstick. Use a clean cloth to wipe off
and screw tightly. Then pull the dipstick out again and read off the oil level. The oil
must be at the full mark at the top (arrow). Replenish oil if necessary. The oil level
must not be higher than the full mark, however.
Insert the dipstick again and tighten.
– After initial filling, remove the "NO OIL" som the top of the engine.
Pos: 16.24 /In
Filling with fuel
Pos: 16.25 /
Safety instruction!
See table for explanation of symbols page 3
Pos: 16.26 /In
– Only fill the tank with fresh and clean unleaded standard petrol.
Fuel with up to 10% ethanol is acceptable.
– Unscrew tank cap.
– Fill tank with fuel using a funnel up to max. lower edge of
– Replace tank cap and screw tight.
Pos: 17.1 /----
Pos: 17.2 /Inne
10 STARTING THE ENGINE
Pos: 17.3 /Inne
Safety instruction!
See table for explanation of symbols page 3
Pos: 17.4 /Inne @ 1
Only start the engine when you are standing behind the mower.
Always place the mower on a level area which is not covered with high grass (if the
grass is too high it will block the cutter bar start-up and make starting the mower more
difficult). When the engine is started, the machine must not be ti
necessary it must be tilted by pressing the guide bar down so that t
pointing in the direction away from the user, but
long as the mower has not been lowered to the ground again, both your hands must be
on the top part of the bar.
Pos: 17.5 /Inne.docx @
CAUTION
Hold the starter cable handle firmly when starting. The handle may otherwi
out of your hand. Risk of i
Pos: 17.6 /Inne
IMPORTANT
The motor only operates when the safety control bracket is pressed against the
upper part of the handlebar. As soon as the safety control bracket i
this returns to its original position under
actuated, and the motor and blade come t
Pos: 17.7 /Inne_1521.
Manual start without electro-start (
Pos: 17.8 /Inne0_
– Push and hold the safety control bar (1) on the top tube (2) D .
– Slowly pull the starter cable (3) until resistance is felt, then rapidly pull it out E –
the engine begins to run, slowly recoil the cable.
Pos: 17.9 /Inne83 @ @ 1
The engine runs with optimum power at maximum speed, which is required for a clean
cutting pattern (engine speed = blade speed).
Pos: 17.10 /Incx @ 134372 @ 2 @ 1
Electro-start models (Illustration
Pos: 17.11 /In @ 1
– Push and hold the safety control bar (1) on the top tube (2) D .
– Turn the ignition key (4) clockwise up to the limit stop, for so long until the engine
starts running P4 .
NOTE
To ensure a long service life of the battery and starter, the starti
never be longer than 5 seconds.
Pos: 17.12 /In683 @ @ 1
The engine runs with optimum power at maximum speed, which is required for a clean
cutting pattern (engine speed = blade speed).
Pos: 17.13 6_1521.docx @ 89 323 @ @ 1
NOTE
Should the electric starter be defective at some point, t
started manually.
– Push and hold the safety control bar (1) on the top tube (2) D .
– Slowly pull the starter cable (3) until resistance is felt; then rapidly pull it out E –
the engine begins to run, slowly recoil the cable.
Pos: 18.1 /----
Pos: 18.2 /Inne0 @ 1 @ 1
11 SWITCHING OFF THE ENGINE (ILLUSTRATION F + P4 )
Pos: 18.3 /Iod_13317
– Release the safety control bar (1) F .
– Remove the ignition key (4) (only for electro-start) P4 .
Pos: 18.4 /----
Pos: 18.5 /Inne
12 EMERGENCY STOPPING
Pos: 18.6 /Inne
Release the safety control lever and the drive switch bar.
– The mower will stop.
– The blade will stop.
– The engine will stop
