Never let the engine start or run whilst the air filter is removed.
Pos: 21.17 /Innenteil/Wartung des Motors/Reinigen bzw. Austausch des Luftfilters Text Motor SAU13340, SAU14508 @ 44\mod_1469090090435_1521.docx @ 504452 @ @ 1
– Open the cover (1), pull down and out and remove.
– Remove the filter element (2) carefully and knock gently onto a smooth surface if
soiled. Replace if heavily soiled or damaged.
– Never lubricate the insert with oil or blow it with compressed air. Severely dirty or
oily filter elements must be replaced.
– After cleaning or replacement, insert the filter element into the air filter plate.
– Insert the hooks (3) on the cover (1) into the seat (4) at the bottom in the air filter
plate.
– Tilt the cover upwards and close with care.
In the case of unfavourable conditions (heavy dust development), the mower must be
cleaned every time it is used, otherwise after 25 operating hours or every year.
(Please see original spare parts and accessories for order no. of filter element)
Pos: 21.18 /Innenteil/Wartung des Motors/1.1 Kontrolle der Zündkerze (Abbildung Y ) @ 0\mod_1115369306250_1521.docx @ 1865 @ 2 @ 1
Pos: 22.2 /Innenteil/Störungsursachen und deren Beseitigung/1 STÖRUNGSURSACHEN UND DEREN BESEITIGUNG @ 0\mod_1115373523343_1521.docx @ 1904 @ 1 @ 1
18TROUBLESHOOTING
Pos: 22.3.1 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/1 Tabellenkopf @ 0\mod_1115374760156_1521.docx @ 1884 @ @ 1
Fault Possible cause Remedy
Pos: 22.3.2 /Innenteil/Störungsursachen und deren Beseitigung/Störu ngstabellenelemente/Motor springt nicht an 40er 550-E-Series, 675EXi @ 45\mod_1470746849571_1521.docx @ 514461 @ @ 1
Engine does not start
up
Control handle not
turned down.
Press the control handle onto
the upper part of the bar D .
Primer pump not
actuated (for model
SA1333, SA1308).
Actuate primer pump
between three and five times
B .
Fuel tank empty. Fill up with clean and fresh
fuel.
Spark plug connector
loose.
Push plug connector in place
or have it checked by an
authorised workshop.
Spark plug defective or
soiled or electrodes worn
out.
Replace or clean spark plug,
set electrode distance Y .
0.7 – 0.8 mm
(for model (SA1733)
0.5 mm (for model
SA1333, SA1308).
Too much petrol feed to
engine (spark plug wet).
Have it checked by an
authorised workshop.
Air filter soiled. Clean or replace the air filter
insert W .
Pos: 22.3.3 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motorleistung lässt nach @ 33\mod_1408527299785_1521.docx @ 241497 @ @ 1
Engine power
decreasing
Air filter soiled. Clean or replace the air filter
insert W .
Spark plug clogged with
soot.
Have it checked by an
authorised workshop.
Fuel old or soiled Empty the petrol tank and fill
with fresh petrol.
Pos: 22.3.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor läuft unregelmäßig @ 0\mod_1127909273145_1521.docx @ 1891 @ @ 1
Engine runs irregularly
Air filter dirty. Clean or replace air filter
insert W .
Spark plug contaminated
with soot.
Have it cleaned by an
authorized dealer.
Have it checked by an
authorized dealer.
Pos: 22.3.5 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Starke Erschütterungen (Vibrieren) @ 0\mod_1115377318234_1521.docx @ 1900 @ @ 1
Extreme vibration
Have it checked by an
authorized dealer
Pos: 22.3.6 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Schnitt unsauber, Rasen wird gelb, Benzin 40er, 43er PRO/S @ 4\mod_1160126243138_1521.docx @ 22067 @ @ 1
Unclean cut, lawn is
yellow
Blade blunt. Have it sharpened and
balanced by an authorized
dealer Q .
Cutting height too low. Adjust to higher cutting height
I .
Engine speed too low. Have it checked by an
authorized dealer.
Mowing too fast. Adjust mowing speed.
Insufficient overlapping
of cuts when mowing.
Tall grass conditions may
dictate that more overlapping
of cuts is required.
Lawn becomes matted. A lawn scarifier can remedy
the problem considerably
Pos: 22.3.7 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Auswurf verstopft, Benzin, TurboSignal MUSTER @ 17\mod_1331728502002_1521.docx @ 134644 @ @ 1
Ejector blocked
TurboSignal ignored
J + K .
Empty the collecting bag L .
Engine speed too low. Have it checked by an
authorized dealer
Cutting height too low
with grass too high.
Set higher cutting height I .
Mowing speed too fast. Adapt mowing speed, switch
motor drive off if necessary.
Grass is damp. Allow the lawn to dry.
Pos: 22.3.8 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Gemulchte Gras sieht schlecht aus Heckauswurf @ 5\mod_1183467132357_1521.docx @ 35950 @ @ 1
Mulched grass
appearance is poor:
clumps, excessive
clippings, rough cut.
Blade blunt. Have it sharpened and
balanced by an authorized
dealer.
Mulching rule not
followed (cut max. 1/3 of
the grass height; the
height of the grass to be
cut must be lower than
10 cm)
Adjust to higher cutting height
I .
Convert mower to rear
discharge U2 + S1 and
mow grass first with higher
cutting setting.
Travel speed too fast. Adjust travel speed.
Grass build-up under
deck.
Adjust to higher cutting height
I .
Insufficient overlapping
of cuts when mowing.
Tall grass conditions may
dictate that more overlapping
of cuts is required
Grass not dry. Adjust to higher cutting height
I .
Let grass dry.
Pos: 22.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungsursachen und deren Beseitigung Text Benzin @ 0\mod_1115378183390_1521.do cx @ 1905 @ @ 1
In case of faults and defects which have not been listed here, please contact the
nearest authorized dealer.
Repairs which require specialized knowledge should only be performed by a qualified
expert. Your authorized dealer will naturally also be glad to help if you do not wish to
perform the maintenance work described here yourself.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Sabo R40 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Sabo R40 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.
The manual is 4,78 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
