Manual Ryobi RPW3200Y (page 10 of 44) (English)

733430

Zoom out

Zoom in

1/44

Soap

short

range

For short range detergent

applications

■ Driveways, walkways, decks

and patios, vehicles, fences,

paint prep, patio furniture, and

lawn equipment

USING THE HIGH-PRESSURE HOSE

The high-pressure hose features an outer

covering that provides strength to the hose.

If the outer covering becomes damaged,

the hose must be replaced immediately. Do

not use a high-pressure hose if the outer

covering is damaged.

To prevent damage to the outer covering:

■ Inspect the hose before every use.

■ Fully unwrap and straighten the hose

before use.

■ Do not allow the high-pressure hose to be

kinked.

■ Keep the hose away from hot surfaces and

sharp edges.

■ Do not pull the product by using the high-

pressure hose.

■ Do not allow the hose to be crushed or

wrapped around objects.

WASHING WITH DETERGENT

See page 31.

Use only detergents designed for high

pressure cleaners. Household detergents,

acids, alkalines, bleaches, solvents,

ammable material, or industrial grade

solutions can damage the pump. Many

detergents may require mixing prior to use.

Prepare the cleaning solution as instructed on

the solution bottle.

NOTE: Spray the detergent on a dry surface

using long, even, overlapping strokes. To

prevent streaking, do not allow detergent to

dry on the surface.

Before shutting off the engine:

■ Remove the soap nozzle, and install the

40 DEG spray nozzle. See the "Installing/

removing nozzles" section.

■ Flush for 1 - 2 minutes (spray clear water

through the spray wand).

■ Shut off the engine.

NOTE: Shutting off (O) the engine will not

relieve pressure in the system. Squeeze the

trigger to release the water pressure.

RINSING WITH THE HIGH PRESSURE

CLEANER

■ Turn off the high pressure cleaner and shut

off the water supply. Squeeze the trigger to

release water pressure.

■ Engage the lock out on the trigger handle

by pushing up on the lock out until it clicks

into the slot.

■ Install the spray nozzle with either the

[40º], [25º], or [0º] setting depending on

the job. Refer to the chart in the "Using the

spray nozzle and soap nozzle" section to

determine which setting is correct for your

application.

■ When using these settings, test a small

area first to avoid surface damage.

■ Start at the top of the area to be rinsed and

work down, overlapping the strokes.

MOVING THE HIGH PRESSURE CLEANER

See page 32.

NOTE: Never lift or carry the product using

the handle and never place it in any position

other than upright on its wheels.

MAINTENANCE

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic

parts. Most plastics are susceptible to damage

from various types of commercial solvents

and may be damaged by their use. Use clean

a cloth to remove dirt, dust, lubricant, and

grease.

WARNING

Do not at any time let brake uids, gasoline,

petroleum-based products, and penetrating

lubricants come in contact with plastic parts.

Chemicals can damage, weaken or destroy

plastic which may result in serious personal

injury.

Only the parts shown on the parts list are

intended to be repaired or replaced by the

customer. All other parts should be replaced

at an authorised service centre.

Before running the engine, perform the

following steps:

■ Check to ensure that all nuts, bolts, and

other fasteners, are securely tightened.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ryobi RPW3200Y in the language / languages: English as an attachment in your email.

The manual is 10,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ryobi RPW3200Y Manual

Product: