31
ENGLISH
The temperature of the room must be between 12°C and
30°C. Set the drip tray and grate in place at the front of
the appliance. Make sure the drip tray is properly fitted
and positioned.
Do not install the appliance near sources of heat or in
places exposed to direct sunlight.
Note: keep in mind that during use the drip tray will have
to be emptied and rinsed regularly. When the BeerTender
system is not being used, you can remove the drip tray
and place it elsewhere to save space.
Warning! The drip tray must be positioned on a level
surface and must not jut out from the surface it is resting
on.
After installing the BeerTender appliance you must clean
the dispensing spout; this is the only part of the
appliance that will come into contact with the beer.
It is vital that you wash the dispensing spout before using
the appliance for the first time and at least every time a
new keg is connected inside the BeerTender system.
This part can also be washed in a dishwasher.
To clean the spout, remove it from its housing by turning
it clockwise.
After washing the spout, screw it back into place.
Connecting to the power supply
Electricity can be dangerous! Therefore you must always
scrupulously abide by the safety rules.
The appliance must be plugged into a suitable, properly
installed electric socket.
The voltage of the appliance has been set in the factory.
Check that the mains voltage matches the voltage indicated
on the rating plate on the bottom of the appliance.
Make sure the main switch on the rear of the machine is
set to “0” before connecting the BeerTender appliance to
the mains.
