7
EN
- Remove your container.
- Your device is ready to froth milk.
FROTHING MILK:
- Place the nozzle in the container of very fresh
cold milk (100 ml) without touching the
bottom and turn the steam function selector
switch (i) to the “ ” position (i3) (fig. 13).
Keep the nozzle in this position for 15
seconds.
- Progressively lower and tilt your container so
that the steam nozzle comes right to the
surface of the milk.
- Once the desired quantity of froth has been
obtained, turn the Steam function selector
switch (i) back to the “O” position (fig. 15).
The appliance automatically cools down
(pump noise). At the end of this operation, the
Coffee indicator lamp (h3) comes on. Hot
water flows into the drip tray (m).
- Your appliance is ready to make an espresso
and finalise your cappuccino.
After the steam has stopped, quickly and
carefully clean the steam nozzle with a damp
sponge (so that the residue does not stick).
Place a container of water under the steam
nozzle and repeat the milk frothing process in
order to clean the nozzle out properly.
To unblock the hole in the steam nozzle outlet,
you may use a needle.
7. CLEANING AND
MAINTENANCE
OF THE APPLIANCE:
Make sure the coffee machine is unplugged
and completely cooled down before you begin
to clean it.
The removable parts can be cleaned using a
cloth and gentle washing-up liquid. water.
Do not immerse the coffee machine in water or
any other liquid.
OF THE FILTER HOLDER HOUSING:
Using a damp cloth, regularly clean the filter
holder housing in order to remove any coffee
residue which may be stuck there.
To prolong the life of the percolation head
gasket seal, do not put the filter holder back
into place if the coffee machine is not to be
used for a long time.
OF THE DRIP TRAY:
The drip tray must be emptied after each time
the appliance is used.
If multiple espressos are prepared one after
another, it should be emptied from time to time
(every 6 cups of espressos approximately)
(fig.17).
The presence of water is normal and is not the
sign of a leak. If necessary, clean the drip tray
(m) and its grid (l) with water and a little gentle
washing-up liquid, rinse and dry.
Make sure the drip tray is put back into place
properly (fig. 18).
8. DESCALING
The warranty does not cover appliances which
become faulty because the descaling
operations have not been carried out
periodically.
The coffee machine must be descaled regularly
as follows:
- Fill the tank with a mixture composed of three
parts water for one part white vinegar or a
mixture of ½ litre of water and a packet of
descaler (both white vinegar and descaler can
be purchased from hardware stores).
Place a container under the filter holder.
Turn the appliance on (fig 4).
- Allow around one third of the liquid to flow
from the tank by turning the Coffee function
selector (h) to the position (h2).
- Stop the appliance by pressing the On / Off
switch (fig. 4), leaving the switch (h) on the
position (h2).
- Wait for 10 to 15 minutes to let the descaler
work.
- Then turn the appliance back on by pressing
the On/Off switch again and let the rest of the
water run from the tank.
- Finally, carry out 2 machine rinse cycles with
a full tank of water in order to flush the
descaler out.
IMPORTANT!
Caution! The steam nozzle is still hot! Careful
you don't burn yourself!
Caution! Do not put any of these parts into the
dishwasher.
