625575
21
Zoom out
Zoom in
Previous page
1/65
Next page
20 V0913 E 300 / E 2800
English Deutsch
Calibration of the scale on the parallel
fence (Fig.21)
Each time a new sawblade is tted the parallel fence scale has to be calibrated to the new
sawblade.
By cutting a sample and measuring its exact length, the scale can be adjusted so that the exact
measure corresponds with the front side of the fence.
After the screw (1) has been loosened the scale can be adjusted. To avoid the fence contacting the
sawblade while it is revolving, the stopring (2) has to be adjusted.
Slide the fence to about 10 mm from the sawblade.
Now slide the stopring (2) across the round guide bar (3) until it comes up against the
casting of the fence. Tighten the lock screw on the stop ring.
Sawguard (Fig.22)
For safety and health reasons it is highly recommended to connect the machine and the saw guard to
a dust extractor system.
Both outlets on the machine (dia.100 mm) and on the saw guard (dia.25 mm) need to be connected,
and the dust extractor should be powerfull enough to obtain an airow of at least 20 m/sec.,
measured at the outlet on the machine.
The guard has to be adjusted in such a way that both main and scoring sawblade are covered, and
should be adjusted in height so that the workpiece can slide under the guard.
Always ensure the locking handle (2) is well tightened.
Fig.22
Fig.21
1
2
3
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland E300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland E300 in the language / languages: English, German as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland E300

Robland E300 User Manual - Dutch, French - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info