625575

Robland E300 Manual

19
Zoom out
Zoom in
Previous page
1/65
Next page
18 V0913 E 300 / E 2800
English Deutsch
Calibration of the scale on the
cross-cut fence (Fig.18)
The scale on the fence is factory set and needs no further adjustments.
To check the settings, put the stop at a certain measure and cut off a sample.
Measure the exact length of the sample, unlock the screw which holds the fence and move the fence
until the measurement corresponds to the length of the previously cut length.
The scale on the telescopic part of the fence is factory adjusted to the scale of the xed part of the
fence.
When using the telescopic extension, the second repetition stop (3) has to be set at
1550 mm to make the different scales correspond with one another. The best way to check if all
scales correspond is to make several test cuts on the different scales.
When, after some time, the wooden protection cap at the front on the cross-cut fence is cut away, a
new one has to be made according diagram g.18.
Mitre fence (Fig.19)
The at T-nut which holds the vertical rod of the wood clamp is factory set and has to stay in its position
to make the angle scale correspond.
To set the required angle : unlock the rod of the wood clamp (1), and the auto-release handle (2). To
slide the fence (5) towards the sawblade, unlock the two handles (3). Reading the angle set is done at
the back of the aluminum bracket which holds the fence.
Always set the aluminium mitre fence prole (4) as close as possible to the saw blade.
To move this aluminium prole, loosen both locking handles on the corner bracket.
Removing the complete mitre fence is easy: loosen the vertical post of the wood-clamp and the locking
handle (2) and take the fence off of the sliding table.
The at nut should always stay in the sliding table groove.
Fig.18
Fig.19
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland E300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland E300 in the language / languages: English, German as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland E300

Robland E300 User Manual - Dutch, French - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info