625575

Robland E300 Manual

18
Zoom out
Zoom in
Previous page
1/65
Next page
E300 / E 2800 V0913 17
EnglishDeutsch
Mounting of the cross-cut table (Fig.16)
The cross-cut table can be slid from the back onto sliding table via the at bar on the side of the
sliding table.
The 2 brackets (2) should be positioned to allow the cross-cut table to be easily moved along the
sliding table. The table is locked in position using handle (1).
Please note that the machine is constructed so that the cross-cut table can only be put at the far end
side of the sliding table.
The telescopic arm support is too short to allow the cross-cut table to be set at the front of the sliding
table. Both telescopic arm and cross-cut table are factory set and need no further adjustment.
Mounting of the 90° cross-cut fence
(Fig.17)
The cross-cut table has 4 precision holes allowing the fence to be put in 2 positions : at the back and
front of the cross-cut table. Simply put the fence onto the cross-cut table and lock it in position
using the two serrated nuts (1).
The 90° right angle of the fence is factory set. Should the 90° angle need to be adjusted, then the two
bolts (2) must be loosened; then by turning the little bolt (1), the angle can be opened or closed
towards the sawblade. After adjustment the bolts (2) have to be retightened.
2
1
Fig.17
1
2
Fig.16
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland E300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland E300 in the language / languages: English, German as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland E300

Robland E300 User Manual - Dutch, French - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info