Manual Robland E300 (page 16 of 65) (English, German)

625575

Zoom out

Zoom in

1/65

E300 / E 2800 V0913 15

EnglishDeutsch

Operating the E-300 sliding table (Fig.15)

When loading panels and when cutting using the parallel fence the sliding table should be

locked.

To lock the table pull the locking lever (1) in one of the three slots in the side cover plate of the

sliding table.

If over a long period of time many short movements of the sliding table are made by e.g. crosscutting

solid wood, then it is possible that the ball carrier between the upper and lower part of the

sliding table will move. This means it will no longer be correctly positioned to allow the sliding table

to slide through its full course.

The operator will feel resistance in the sliding table motion and the full stroke will not be achieved.

This effect can be corrected simply by pushing the table with a few short, light pushes against the

buffer stop at the end, until the position of the ball carrier is adjusted and the table can be moved

again along its full stroke.

Maintenance and lubrication of the sliding table

It is highly recommended to clean the sliding table once a week, and to remove all sawdust and chips

which gradually slow down the sliding table. From both sides of the sliding table blow out the dust

which has accumulated between the two sections and on the ball carrier.

This can be done more easily and efficiently when the upper part of the sliding table is slid to the rear,

and must then be repeated with the upper part at the front end.

After all dust has been blown out, a thin oil, such as WD-40, should be sprayed onto the steel inserts

on both the upper and lower part of the sliding table. Never use a thick oil or grease ! This

maintenance job will only take 10 minutes of your time, and will ensure the

machine gives full satisfaction.

Fig.15

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robland E300 in the language / languages: English, German as an attachment in your email.

The manual is 3,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland E300

Robland E300 User Manual - Dutch, French - 65 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robland E300 Manual

Product: