625586
53
Zoom out
Zoom in
Previous page
1/94
Next page
52 V1112 D 630
Nederlands Français English Deutsch
Change and tensionning of the belts (Fig.9)
The belts of the main motor can be tensionned as follows: Unlock the 3 bolts which holds the motor-
support bracket onto the frame and wind the belt spanner bolt up or down in order to tension the belts.
After belt tensionning is done, lock again the 3bolts. The drive belts are of the type: SPA 1750.
Tensionning the drive chain (Fig.10)
The drive chains need no tensionning since the tension is always assured by an idle chain spanner.
To change the drive chain, pull the chain spanner backwards and remove the chain from the sprockets
and remove the chains. After the chain is replaced always assure the chain spanner is well placed onto
the chain. To change the drive chain for the rise and fall of the table, pull the chain spanner lever to
the back and remove the chain. Attention: do not turn the sprockets on one of the 4 posts of the table
whilest chainging the chain; this will lead into a disorder of the parallelism of the table!
Fig.9
Fig.10
Motor xing bolts
Hefboom kettingspanner
Belt spanner bolt
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland D630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland D630 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info