Manual Robbe Futaba T8FG (page 58 of 123) (English)

467089

Zoom out

Zoom in

1/123

●Selectthefunction name

and return to the Linkage

menu by touching the

RTN button.

<SensorTouch™>

SUB-TRIM

Setting of neutral position of each servo.

(The display screen is an example. The

screen depends on the model type.)

The Sub-Trim function is used to set the servo

neutral position, and may be used to make fine

adjustments to the control surface after linkages

and pushrods are hooked up. When you begin to set

up a model, be sure that the digital trims are set to

their center position.

Sub-trim adjustment

1. Move the cursor to the channel you want to

adjust and touch the RTN button to switch to

the data input mode.

2. Adjust the rate by scrolling the touch sensor.

Initial value: 0

Adjustment range: -240~+240 (steps)

(When the RTN button is touched for one second, sub-trim is

reset to the initial value.)

*Before sub-trim adjustment, it is very important to adjust the

linkages at the control surface so that you do not use sub-

trim, except for very minute adjustments.

3. Touch the RTN button to end adjustment and

return to the cursor mode.

4. Repeat this procedure for each channel.

●Select[SUB-TRIM]intheLinkagemenuandaccess

the setup screen shown below by touching the

RTN button.

Scrolling

●Movingcursor

●Adjustingvalue

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robbe Futaba T8FG in the language / languages: English as an attachment in your email.

The manual is 10,13 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robbe Futaba T8FG

Robbe Futaba T8FG User Manual - German - 72 pages

Robbe Futaba T8FG User Manual - Dutch - 123 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robbe Futaba T8FG Manual

Product: