744646
35
Zoom out
Zoom in
Previous page
1/48
Next page
|35
34
EN
Loosen the screw of the flame sensor. Remove the flame sensor and
the silicone hose from the pressure pipe as well.
Loosen the marked screw from the stove. This is used to secure the
air deflector below.
Then mount the support plate with 5 screws to the stove.
Couple the silicone hose to the pressure pipe again (1-2cm).
Thread the flame sensor through the oval hole in the support plate
and fix the pressure bracket with the screw.
Mount the flame sensor cover to this support plate. The flame sensor
cable must be routed through the slotted cover to the outside. Then
screw on the fan housing with 3 screws.
Tip
If you install both convection fans, remove now the lower round
cover and the cable channel and fit here the second fan housing.
Mount the cable channel again after screwing the second
convection fan.
Insert the wires from flame sensor and fan motor in the cable
channel and put on the lid.
To fix this and to avoid vibrations, twist the two tabs (located
diagonally) with pliers.
#8
#8
#8
#8
#8
#10
#8
#8
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Domo Multiair at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Domo Multiair in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 19,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info