744646
34
Zoom out
Zoom in
Previous page
1/48
Next page
34
General information
Q The convection air amount and temperature is designed for
heating one or, if two fans are installed, two additional rooms.
Q Note the regional specific fire safety regulations and clarify the
connection situation with the competent authority.
Q The max. temperature of the convection air is 180° C at the air
outlet.
Q The convection air duct should be as short as possible.
Q Keep the number of deflections as small as possible.
Note
Please pay attention to the national and country-specific building
and fire regulations when connecting the convection air pipes.
Installation and assembly must be performed by a trained
specialist only.
The option MultiAir is basically only with the lower flue pipe
connections (rear / rear center / side) possible. If only one convection
fan is mounted, it can be combined with the increased rear
connections. In this case, leave out the lower air deflector.
Note
Only work on the unit when the mains plug has been disconnected
and the stove has cooled down completely.
Note
During assembly / dismantling do not allow objects (screws etc.) to
fall into the pellet container – they can block the screw conveyor
and damage the stove.
Note
During any conversion work, take particular care of your fingers
and any panels and stove attachments. Select soft bases to
prevent scratches to your living space furniture and stove panels.
Mounting Convection Fan
Prepare the following at the stove:
Loosen the 4 screws on the rear panel. The rear panel tilts backwards,
then you can lift it off.
Depending on the desired option cut off the two upper markers for
one fan, for the second fan in addition the two bottom markers.
The pre-assembled fan unit must be disassembled for installation.
Loosen the screws and remove the entire fan housing with motor
and the oval sensor cover. Remove the cable cover which is secured
with cable ties.
Now mount the lower air deflector on the support plate of the fan.
From serial number 1426751onwards the heat shield must be
removed prior to assembly. Undo the marked screws of the stove
and remove the heat shield. The heat shield will no longer be needed
after disassembly and can therefore be discarded.
#25
#8
#10
#8
#8
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Domo Multiair at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Domo Multiair in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 19,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info