792895

Respekta PYRO 9 TOUCH Manual

55
Zoom out
Zoom in
Previous page
1/71
Next page
18
6、Self-cleaning function
In the function to be selected mode, select the self-cleaning mode. The default temperature
is not adjustable. The default working time is 1:00 hours. It can be adjusted by using “+” or
“ ” time. The working time range is minimum 1 hour, maximum 2 hour.
After setting the working time under the self-cleaning mode , touch “ ” to start working.
At this time,“ ” shows, door lock activates, the “ ” and “ ”displayed constantly. At
this point, the oven door is locked, the oven self-cleaning function is activated, and the
“ ” can be pressed to pause the function.
After confirming that the self-cleaning function is activated, the clock position displays the
working time countdown and the temperature position displays“ ”.
After the self-cleaning function is activated, door lock function is automatically opened and
the oven door is locked. At this time, the self-cleaning gear starts to work. If the self-
cleaning function is activated, the program automatically prompts the error code and the
display shows “E-3”. For specific cause analysis, please refer to the part of “protection
function 11.5.3~11.5.4”. You can press and hold the power key“ ” to cancel the error code
and the program returns to the standby state. After troubleshooting, reset the self-cleaning
function, and then press the “ ” key to start working.
7、Attentions for self-cleaning function
7.1 Before use of the self-cleaning function, all the accessories such as the wire rack, oven
pan and side shelves must be taken out of the oven, otherwise the high temperature will
damage the fittings.
7.2 After using the self-cleaning function, do not use water or other washing agents.
7.3 After use the self-cleaning function, you may find matter which was not removed in the
side of the cavity, this is normal. Use a microfiber cloth to clean them.
7.4 In order to achieve a better self-cleaning effect ,you can take out the all accessories of
the oven and cleaning the oven simply before using the self-cleaning function.
7.5 Before using the self-cleaning function, it is necessary to remove too much food residue
and oil in the oven for cleaning. Because too much food residue and oil inside of the oven
will be burned when the temperature in the oven is too high, which is very dangerous. Will
produce a large smoke and irritating odor during the self-cleaning work process.
7.6 When using the self-cleaning function, the external glass surface temperature is very
high. Do not touch the case and glass surface with your hands to prevent burns. Children
must be kept away from the oven to avoid burns.
7.7 When the seal of oven is found to be poor effect or damaged, other sealing strips should
not be used instead. Special sealing strips should be replaced in time so as not to affect the
effect of each function.
8、Door lock function
8.1 Door lock display: After the self-cleaning is finished,the system enters into the standby
mode.When the oven cavity temperature are higher than 280,the screen displays the icon
“”(See pic 9). The door lock is automatically unlocked when the oven cavity temperature
is below 280 ,and the door lock icon“ ”will disappear.See pic 10.
… 55 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Respekta PYRO 9 TOUCH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Respekta PYRO 9 TOUCH in the language / languages: English, German as an attachment in your email.

The manual is 1.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info