587906
36
Zoom out
Zoom in
Previous page
1/44
Next page
36
REMKO GPM
Troubleshooting
Troubleshooting
JA
NEIN
JA
NEIN
JA
JA
NEIN
NEIN
JA
Ja
BETRIEB NORMAL
NEIN
Siehe
Störungs-
ursachen
Gerät
blockiert
Erscheint auf
dem Display die
Temperatur?
Ist der Brenner
eingeschaltet?
Ist die ausgeblasene
Umluft warm?
Läuft der Brenner auf
Höchstleistung?
Wärmeleistung
unzureichend
Erscheint
dieses Symbol auf
dem Display?
a) Netzanschluss
b) Buskabelverbindung
zwischenTemperaturregelung
und Steuerplatine
c) Elektromagnetische Störungen
d) Temperaturregelung mit ent-
sprechender Taste zurückstellen
e) Temperaturregelung defekt
Kontrollieren:
!
Erscheint
das Symbol
des Heizkörpers
im Display?
Ja
Kontrollieren:
Temperaturregelung
steht auf Stand-By
Temperatur-
regelung auf
ON Stellen
NEIN
NEIN
Anzeige des Wasserhahn-Symbol:
An der Temperaturregelung
die Heizphase auf ON Handbetrieb oder
ON Automatikbetrieb stellen
Fehler
auslesesen
Prüfen, dass der RegSan-Wert
höher als der vom NTC1 Fühler
gemessene Wert eingestellt ist.
a) Kontakt 7-9 geschlossen
b) Wechselschalter auf Winter
T
Blinkt
dieses Symbol
im Display der
Temperaturregelung?
Kessel Reset
Betrieb
Wand-Heizautomat
REMKO GPM
We reserve the right to make changes to dimensions and design in the interest of technological advances.
Operation of
REMKO GPM wall
heater
Is the burner
switched on?
Heat output
inadequate
Unit blocked
Checks:
a) Mains connection
b) Bus cabling between
temperature control and
control board
c) Electromagnetic interference
d) Reset temperature control with
appropriate button
e) Temperature control faulty
Clear fault
See Trouble-
shooting guide
Set tempera-
ture control to
ON
Temperature control
set to standby
Check:
a) Contact 7-9 closed
b) Changeover switch set to winter
NORMAL MODE
Water tap symbol display:
At the temperature control, set the heating
phase to ON manual mode ON automatic
mode.
Check that the Reg-San value is
set higher than the value
measured by the NTC1 sensor.
YES
NO
YES
YES
YES
NO
NO
YES
YES
NO
NO
YES
NO
NO
Does
this
symbol flash
in the temperature
control display?
Does
this
symbol appear
in the display?
Is the
burner
operating maximum
capacity?
Is
the blown out
circulation air
warm?
Does
the
temperature appear
on the
display?
Does
the radiator
symbol appear in
the display?
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO GPM 25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO GPM 25 in the language / languages: English as an attachment in your email.

The manual is 4,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO GPM 25

REMKO GPM 25 User Manual - German - 44 pages

REMKO GPM 25 User Manual - Dutch - 44 pages

REMKO GPM 25 User Manual - French - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info