616921

Remington IPL6000F Manual

6
Zoom out
Zoom in
Previous page
1/95
Next page
1110
ENGLISHENGLISH
, Treat body area(s) with the i-Light device
Thei-Lightdeviceisequippedwithtwooperatingmodes:SingleFlashModeandMulti-FlashMode.Your
i-Light device will automatically be set to Single Flash Mode each time the device is powered ON.
Single Flash Mode:Thei-LightdevicewillashoncewhentheFlashButtonispressedANDskincontact
sensor is engaged.
Multi-Flash Mode:Thei-Lightdevicewillashonceevery2secondswhentheFlashButtonispressedAND
the skin contact sensor is fully engaged.
The Multi-Flash mode allows you to quickly treat large areas such as the legs, chest or back by simply gliding
thehandpiecetoanewlocationaftereachash.
, Single Flash Mode
1. Placethei-LighthandpieceagainstyourskinsotheFlashWindowisushwiththeskinsurface(g.11).
2. Ensure the Skin Contact Sensor is fully engaged and the Bulb Status Indicator Display
is illuminated.
3. Press the Flash Button to activate the device (fig. 12).
4. Move the hand piece to a new treatment area and repeat steps 1-3 (fig. 13).
, Multi Flash Mode
1. Placethei-LighthandpieceagainstyourskinsotheFlashWindowisushwiththeskinsurface(g.11).
2. Ensure the Skin Contact Sensor is fully engaged and the Bulb Status Indicator Display
is illuminated.
3. Press AND HOLD the Flash Button down to activate the device (fig. 12).
4.Immediatelyafterthedevicehasashed,slidethehandpiecetoanewlocation.Afterashortdelay
(approximately2seconds)thedevicewillashagain(g.13).
NOTE:
• DuringMulti-FlashMode,theSkinContactSensorANDtheFlashButtonmustremainfullydepressed.If
either becomes disengaged, the device will not operate. To resume treatment, repeat steps 1-4.
• DuringMulti-FlashMode,theBulbStatusIndicatorDisplaywillremainilluminatedwhiletheSkinContact
Sensor and Flash Button are engaged.
Fig. 11
Fig. 12
Fig. 13
C
FACIAL TREATMENT ATTACHMENT
, Treat facial area(s) with the i-Light device (female use only)
Facialhaircanbeverydierenttobodyhairandtheskinonthefacetendstobesensitiveandmorelikely
tobeexposedtothesun’sUVrays;thereforetreatingunwantedfacialhairisdierenttotreatingthe
body – please be sure to read this section carefully before beginning a facial treatment.
F IMPORTANT: The Facial Treatment Head has been specially designed to treat the unique
characteristics of female facial hair. DO NOT use the body attachment on the face. See section ‘Changing
Treatment Heads’ for instructions on how to exchange heads.
, Where you can use the facial treatment head.
The Facial Treatment Head is intended for use on female facial hair on the cheeks, sideburns, chin, neck
areas and above the lips as shown in fig. 14.
Fig. 14
Each Sideburn
Each Cheek
Above Lips
Chin
Neck
F DO NOT use on male beards or facial hair as the results may be permanent or uneven which may
produce changes in facial characteristics which may not be desirable.
A
WARNINGS AND PRECAUTIONS - FACIAL USE
F DO NOTuseanywhereneartheEYES,EYEBROWSorEYELASHES.Whenusedasdirectedthelight
should not harm the eyes, however if the scattered light is unpleasant you may wish to close your eyes or
look away.
F DO NOT treat SUN BURNED or TANNED SKIN. Wait until the sunburn or tan has completely faded
before beginning a treatment. Remove cosmetics, lotions and creams (including self-tanning products)
prior to treatment. After treatment, use a fragrance-free lotion (SPF 30+) and try to avoid direct sun
exposure to the treated area for at least 24 hours.
F DO NOTashtheLIPSorotherDARKSPOTS(darkfreckles,moles,birthmarksortattoos)astheseareas
mayabsorbtoomuchlightenergywhichmaycausediscomfortorpain.Youcancovertheseareaswith
WHITEeyeliner,adhesivelabelsorthickpapertoreectthelightincaseofaccidentalashing.
GB
DNLFEIDKSFINPSK
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remington IPL6000F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remington IPL6000F in the language / languages: All languages as an attachment in your email.

The manual is 10,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info