13405
18
Zoom out
Zoom in
Previous page
1/33
Next page
9Chapter 2: Installation
2.2.3 Connection to External Navigation Equipments
The diagram shown below should be followed to make connections of
the NMEA 0183 data to external units. A terminal strip would provide a
convenient means for attaching the necessary inputs and outputs.
WARNING:
OBSERVE PROPER POLARITY!
The 12VDC power leads should normally be routed to the ship’s DC
power distribution panel on larger boats. The unit draws approximately
0.25 amps, so connection to a circuit breaker rated at 5 amps or less is
recommended. On smaller vessels the power leads should be
connected to a panel switch or to the main battery isolation switch or
breaker.
For best noise immunity from other shipboard electronics, avoid
grouping the GPS sensor power connections together with the radar,
radio, or echo sounder power leads on the same circuit breaker, if
possible. The GPS’s wiring should be separated as much as possible
from these other devices.
When using the NMEA 0183 format, the Raystar 112 can provide data
for at 2 or more navigation equipments when connected in parallel. Be
sure that all devices connected to the data output ( plotters, video
sounders, radars) are programmed to use the NMEA 0183 data format.
WARNING:
Do NOT GROUND the Data, Data return lines, or the
Shield of the interface cable at any of the external navigation
equipments.
Interface between equipments is normally completed by using a two
wire, twisted pair, shielded, cable. If you are using a terminal strip as
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raystar 112 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raystar 112 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info