13405
17
Zoom out
Zoom in
Previous page
1/33
Next page
8 RAYSTAR 112 Installation and Operation Handbook
Data Input to Sensor
The sensor data input line is used to provide initialization data to the
sensor unit as well as other set-up information, such as geodetic datum
selection. This data is ordinarily provided via Raytheon’s GPS display
units (RayNav 298, RayNav 398, etc.).
2.2.1 Connection to Raytheon Units
When the Raystar 112 sensor is connected directly to one of
Raytheon’s GPS display units, it normally obtains its 12VDC operating
power input from the unit. In this typical installation, the 6 pin sensor
connector is plugged directly into the connector labeled “GPS” on the
rear of the display unit cabinet. The DC power is then supplied via pins 1
and 2 of the GPS connector to the sensor.
Other external equipment requiring GPS data input should obtain their
required NMEA 0183 data via connection to the data output wires
located in the NAV display unit power cable assembly.
2.2.2 Connections to DGPS Receiver
The Raystar 112 is designed to accept differential corrections in the
RTCM Version 2.1 format from the Raytheon DGPS Beacon Receiver.
The corrections from the Beacon receiver pass directly to the GPS
sensor. A convenient “Y” cable assembly is packaged with the Beacon
receiver to permit this interconnection. The diagram below shows the
configuration.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raystar 112 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raystar 112 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info