13405
16
Zoom out
Zoom in
Previous page
1/33
Next page
7Chapter 2: Installation
the cable is fed externally through the slot, the cable should be tyrapped
or clamped at the base. Then the slot in the base should be sealed with
RTV silicon sealant.
The cable assembly supplied is 33 ft (10 m) in length with a 6 pin
connector installed at the receiver end. The cable should be run as
directly as possible to the navigation console or to the external
navigation device. The cable may either be cut as necessary to the
desired length or coiled and stored out of the way.
If the cable is cut to length, the cable may be rejoined by following the
connection diagram in section 2.2.4.
2.2 Sensor Connections
The Raystar 112 sensor has the following input/output requirements:
DC Power
The 12 VDC power input to the sensor should be in the range of 11 to
16 VDC. It is important to verify that these voltage limits will not be
exceeded to protect the GPS sensor unit. The negative leg of the 12V is
grounded at the sensor base. If the vessel has a floating 12VDC
system, an insulator must be used between the sensor base and mount
to isolate the sensor from the ships ground.
NMEA 0183 Data Output
The NMEA 0183 Data contains RMC, GLL, VTG, GGA, GSA and GSV
sentences. Please note that the sensor output is guaranteed to drive
only 2 (two) devices directly. When using modern low current NMEA
0183 listener devices, up to 5 units can be driven in parallel. Contact
your dealer if there are any questions regarding interfacing capabilities.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raystar 112 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raystar 112 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info