815524
29
Zoom out
Zoom in
Previous page
1/40
Next page
29 7027-802M 04/23
Figure 29.1
19. Snap Disc #3 (Back Burn Protector) 250°F
Snap disc #3 is mounted on the side of the auger tube just
below the feed motor and has a red reset button. To access
it remove the feed motor cover box from inside the hopper.
If the re tries to burn back into the feed system or push
exhaust up the feed tube, this snap disc will shut the entire
system o󰀨. This disc must be manually reset.
20. Vacuum Switch
The vacuum switch is located on the left side of the
appliance behind the inner shield. This switch turns the
feed system on when vacuum is present in the rebox.
The vacuum switch is a safety device to shut o󰀨 the feed
motor if the exhaust or the heat exchanger system is dirty
or plugged or if the rebox door is open.
21. Wiring Harness
See Figure 29.1 below.
16. Thermostat
The appliance is designed to run on a 12 volt AC thermostat.
The heat anticipator should be set on the lowest setting
available.
17. Snap Disc #1 (Convection Blower) 145°F
Snap disc #1 is located on the right side of the appliance
on the top of the heat exchanger box. There are 2 purple
wires connected to it. This snap disc turns the convection
blower on and o󰀨 as needed. Power is always present at
snap disc #1.
18. Snap Disc #2 (Thermostat Override) 200°F
Snap disc #2 is also located on the right side of the appliance
between snap disc #1 and convection blower. There are 2
yellow wires connected to it. This snap disc will turn o󰀨 the
feed system, which will turn o󰀨 the appliance if an over re
condition should occur or if the convection blower should
fail to operate.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Classic Bay 1200 Pellet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Classic Bay 1200 Pellet in the language / languages: English as an attachment in your email.

The manual is 5.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Classic Bay 1200 Pellet

Quadra-Fire Classic Bay 1200 Pellet User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info