Manual Quadra-Fire Classic Bay 1200 Pellet (page 28 of 40) (English)

815524

Zoom out

Zoom in

1/40

28 7027-802M 04/23

A. Component Functions

1. Control Box

a. The control box is located under a small cover in the

right rear corner of the inside of the hopper.

b. There is a light located inside of the control box. The

internal light will turn green when the appliance has

reached a temperature of 200°F (93°C) in the re pot

and will turn red when it reaches 600°F (315°C).

c. There is also an internal blue light located in the

upper left corner of the control box. When you plug

in the appliance the blue light will automatically start

blinking 1 blink every 10 seconds for the rst 60

seconds and then will stop.

NOTE: Do NOT open the control box. This will void the

warranty. If you need to plug in or remove the control box

you must rst unplug the appliance.

When describing the location of a component,

it is always AS YOU FACE THE FRONT OF

THE APPLIANCE.

6 6 Reference Materials

7. Heat Exchangers

The heat exchangers transfer hot air from the exhaust

system into convection air. Lift the appliance top to access

the heat exchangers. There are 2 clean out rods located

under the heat exchangers.

8. Heat Output Switch

The heat output switch is located on the upper right side

panel. The function of the heat output switch is to regulate

the burn rates; low, medium, and high settings.

9. Hopper Switch

The hopper switch is located in the upper right hand corner

of the hopper. This switch is designed to shut down the feed

motor whenever the hopper lid is opened.

10. Igniter

The igniter is mounted on the base of the re pot. Combustion

air travels over the red hot igniter creating super heated air

that ignites the pellets.

11. Junction Box And Wiring Harness

The junction box is located on the right side of the appliance,

behind the interior shield. The junction box and wiring

harness are replaced as one component.

12. Power Supply

The power outlet is located on the back of the appliance,

lower right corner. Check the wall receptacle for 120 volt,

60 Hz (standard current). Make sure the outlet is grounded

and has the correct polarity. A good surge protector is

recommended.

13. Red Call Light

The red call light is on the front of the junction box, next

to the reset button. The function of the red call light is to

indicate that the thermostat is calling for heat.

14. Reset Button

The reset button is located on the right side of the appliance

next to the red call light. The function of the button is to

momentarily open the thermostat circuit, which restarts the

system.

15. Thermocouple

The thermocouple is located on top of the re pot inside

the thermocouple cover (ceramic protection tube). The

thermocouple sends a millivolt signal to the control box

indicating the preset temperatures of the green and red

lights have been obtained.

2. Convection Blower

The convection blower is mounted at the bottom rear of the

appliance. There are 2 impellers, one on each side of the

motor. The convection blower pushes heated air through

the heat exchange system into the room.

3. Combustion (Exhaust) Blower

The combustion blower is mounted on the lower left side

on rear of appliance. The blower is designed to pull the

exhaust from the appliance and push it out through the

venting system.

4. Feed System

The feed system is located in the hopper under the feed

motor cover box on the left side of the appliance and can

be removed as an entire assembly. The assembly includes

the feed motor, mounting bracket, bearing and feed spring

(auger). The hollow feed spring (auger) pulls pellets up the

feed tube from the hopper area and drops them down the

feed chute into the re pot.

5. Fire pot

The re pot is made of high quality ductile iron and has

a cleaning pull-out rod. The oor of the re pot opens for

cleaning when you pull out the rod. Be sure that the oor

returns to a completely closed position or your appliance

will not operate properly.

6. Fuse

The fuse is located on the front of the junction box on the

right side of the appliance. The fuse will blow should a short

occur and shut o󰀨 power to the appliance.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Classic Bay 1200 Pellet in the language / languages: English as an attachment in your email.

The manual is 5.89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Classic Bay 1200 Pellet

Quadra-Fire Classic Bay 1200 Pellet User Manual - French - 40 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Quadra-Fire Classic Bay 1200 Pellet Manual

Product: