815528
12
Zoom out
Zoom in
Previous page
1/40
Next page
12 02/237022-802K
L. Insert Removal
In the case that service or inspection is required the
appliance may need to be removed from the wall.
1. Appliance must be unplugged before removal of
appliance is possible. Unplug the appliance from its
power source.
2. Remove insert surround from appliance, to ease the
process of removal.
3. Non-clip the exhaust transition from the exhaust outlet
in the back of the appliance. This is what connects
the venting to the appliance. Removal of the clips will
allow you to remove the appliance from the wall without
damaging or adjusting the venting.
4. Slide appliance from the wall and rotate either direction
as needed.
K. Ignition Cycles
1. During each ignition cycle, it is normal to see some smoke
in the rebox. The smoke will stop once the re starts.
2. The convection blower will automatically turn on after
your appliance has reached the set temperature. This
blower transfers heat from your appliance into the room,
and will continue to run after the thermostat has stopped
calling for heat until the appliance has cooled down.
3. Occasionally the appliance may run out of fuel and shut
itself down. When this happens, the red call light will be
on (Figure 10.1 on page 10). To restart it, ll the hopper
and press the reset button. When you press the reset
button the red call light will go out. Release the button
and the light will come back on. You should see a re
shortly. If not, follow Starting Your First Fire instructions
on page 10.
M. Restarting the Appliance
Restart Process
1. When the unit has run out of fuel, add pellet fuel to
the hopper.
2. Dump the ashes and clinkers built up in the re pot by
pulling the ash dump removal handle out several times.
Make sure clinkers have dropped into the ash pan then
return the handle to fully closed position.
3. Press the reset button; the appliance will then being its
startup sequence.
Restarting After a Power Failure
1. For an electrical disruption the appliance will start on
its own without need for priming - providing the control
system is asking for heat.
2. The appliance will always go through a normal shutdown
sequence before restarting.
N. Clear Space
NOTICE: Clearances may only be reduced by means
approved by the regulatory authority having jurisdiction.
Fire Risk
Do NOT operate appliance:
With appliance door open.
Fire pot oor open.
Cleaning slide plates open.
WARNING
Do NOT store fuel:
Closer than required clearances to combustibles to
appliance
Within space required for loading or ash removal.
HOT WHILE IN OPERATION. KEEP CHILDREN,
CLOTHING AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS.
CAUTION
Mantel: Avoid placing candles and other heat-sensitive
objects on mantel or hearth. Heat may damage these objects.
Fire Risk.
Do NOT place combustible objects in front of
the appliance. High temperatures may ignite
clothing, furniture or draperies. Maintain a
minimum clearance of 3 feet (914mm) in
front of appliance.
WARNING
Fire Risk.
Keep combustible materials, gasoline and
other ammable vapors and liquids clear of
appliance.
WARNING
Do NOT store ammable materials in the
appliance’s vicinity.
DO NOT USE GASOLINE, LANTERN FUEL,
KEROSENE, CHARCOAL LIGHTER FLUID OR
SIMILAR LIQUIDS TO START OR “FRESHEN UP” A
FIRE IN THIS APPLIANCE.
DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS
SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL.
DO NOT USE CHEMICALS OR FLUIDS TO START
THE FIRE.
Keep all such liquids well away from the appliance
while it is in use.
Combustible materials may ignite.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Castile - Pellet - Insert at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Castile - Pellet - Insert in the language / languages: English as an attachment in your email.

The manual is 9.65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Castile - Pellet - Insert

Quadra-Fire Castile - Pellet - Insert User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info