738849
18
Zoom out
Zoom in
Previous page
1/24
Next page
MOUNTING THE RADIO RECEIVER
Plug the radio receiver into a mains socket. Then plug
the device to be switched into the socket of the
radio receiver.
NOTE
The radio receiver should not be mounted behind
a metal cover, as this will restrict the range.
ATTENTION!
Always check whether the power consumption
of the connected device does not exceed the
switching capacity.
MOUNTING THE RADIO TRANSMITTER
Remove the battery compartment cover (6) by
pressing lightly and simultaneously pushing in the
direction of the arrow. Insert the battery (CR2032)
into the radio transmitter with the correct polarity
(positive pole upwards) and slide the switch (7) into
position “I” to switch on the radio transmitter. Slide
the battery cover back onto the transmitter housing.
Mount the radio transmitter (2) on the casement
of the window to be monitored. Make sure that
the minimum gap size is taken into account (see
“Minimum width of window opening”).
1. To attach the radio transmitter, you can either use the
two supplied adhesive pads or 2 screws, which are
inserted through the two slots on the radio transmitter
and screwed into the window casement. Before you
screw in the radio transmitter, make sure that the
position of the radio transmitter is correct.
2. Attach the magnet housing (3) to the window frame
behind the radio transmitter so that the distance
between the magnet housing and the arrow mark on
the radio transmitter is not more than 7mm when
the window is closed. The magnet housing can either
be attached to the window frame with the enclosed
adhesive pad or with a screw. To do this, open the
magnet housing by levering out the lower part (3c)
with a suitable screwdriver.
3. If the magnet housing does not fit close enough to
the radio transmitter, you can reduce the distance
using the washers (U) supplied.
4. After the washers and the bottom part of the magnet
housing have been fixed, reinsert the magnet (3b) and
then replace the upper part of the housing (3a). Make
sure that the upper part of the housing engages correctly.
EN
18
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Protector AS-410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Protector AS-410 in the language / languages: English, German as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info