7
PULSE 2
These instructions are to be used with the HealthRider T90
with a TV.
1. Make sure that the power cord is unplugged. Remove
the indicated Screws from the Console Back (A).
Important: The Screws may be different lengths. Keep
track of which Screws were removed from which holes.
2. Raise the Console (C) enough to view the back of the
Console. Peel the paper off the pad on the bottom of the
Receiver (B). Turn the Receiver so the cylinder is on
the side shown, and press the Receiver onto the back of
the Console in the indicated location.
3. Connect the Short Jumper Wire (D) to the wire on the
Receiver (B). Connect the other end of the Short Jumper
Wire to the PULSE 2 jack on the back of the Console (C).
If there is a wire already plugged into the PULSE 2 jack,
unplug it. Note: The included Long Jumper Wire can be
discarded. The Wire Tie can be used to tie wires if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (C) with the Screws. Important: If
the Screws are not put back into the same holes that
they were removed from, the Console will be dam-
aged.
Screws
A
C
1
