6
D
Note: If you have a PROFORM 785Pi or model number
PFTL79100, please call 1-800-999-3756.
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
Remove the Console Back from the Console Base (E).
2. Locate the loose Pulse Wire (C) inside the Console Base
(E). Connect the Pulse Wire to the wire on the Receiver
(D). Next, peel the paper off the pad on the bottom of the
Receiver (D). Turn the Receiver so the small cylinder
is on the side shown, and press the Receiver into the
bottom of the Console Base (E) in the location indicated
by the dotted line. Note: The two included jumper wires
can be discarded. The Wire Tie can be used to tie wires if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console Back (B) with the Screws (A).
B
E
A
1
C
2
Cylinder
1. Make sure that the power cord is unplugged. Remove
the Screws (A) from the Console Back (B). If the Screws
are different lengths, make sure they are returned to the
same hole. Remove the Console Back from the Console
Base (C). Note: The number of Screws and the location
of the Screws may vary depending on the model of your
treadmill.
3. Connect the Long Jumper Wire (D) to the PULSE #1 jack
on the back of the Console (E) (refer to the inset draw-
ing). Connect the other end of the Long Jumper Wire to
the wire on the Receiver (F). Next, peel the paper off the
pad on the back of the Receiver. Turn the Receiver so
the cylinder is on the side shown, and press the
Receiver onto the back of the Console Base (C) in the in-
dicated location. Note: The included Short Jumper Wire
can be discarded. The Wire Tie can be used to tie wires if
needed.
Make sure that no wires are pinched. Refer to step 1
and reattach the Console Back (B).
B
A
1
