5
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
Remove the Console Back from the Console Base (C).
3. Connect the Long Jumper Wire (E) to the PULSE jack on
the back of the Console (F). If there is a wire already
plugged into the PULSE jack, unplug it. Feed the Long
Jumper Wire through the hole in the side of the Console
Base (C).
4. Connect the Long Jumper Wire (E) to the wire on the
Receiver (G). Next, peel the paper off the pad on the
back of the Receiver. Turn the Receiver so the cylinder
is on the side shown, and press the Receiver onto the
back of the Console Base (C) in the indicated location.
Note: The included Short Jumper Wire can be discarded.
The Wire Tie can be used to tie wires if needed.
Make sure that no wires are pinched. See steps 2 and
1. Reattach the Console (F) and the Console Back (B).
2. Have a second person hold the Console Base (C) as you
remove the indicated Screws (D) from the Console Base.
B
C
A
1
C
2
C
3
PULSE Jack
E
F
C
Cylinder
4
E
G
D
