721953
7
Zoom out
Zoom in
Previous page
1/11
Next page
6. USE, OPERATION
6.1 Use
6.1.1 Controller: It is the key component of a wheelchair. All electronics
to operate the latter are housed in it(figure 18). Usually the controller is
installed in one armrest, which is connected with motor and battery on
power box.
On/off button: this button supplies the power for the electronic
components of the control system, the control system supplies the
power to the motors of the wheelchair. Do not use the on/off button to
stop the chair unless there's an emergency situation. Otherwise it may
shorten the life of the wheelchair drive components.
Joystick: The joystick is mainly used to control the wheelchair’s
movement including its speed and direction(forward, backward and left
or right etc). The futher you push the joystick from its central position,
the faster the wheelchair moves. Whenever you release the joystick, it
will automatically go back to the center and the brake will be
automatically operative to stop the wheelchair.
Horn button: The horn will sound if you press this button.
Speed Up/Down Buttons and Speedometer: After turning on the power,
the speedometer shows the current maximum speed setting. This
maximum speed setting can be adjusted through the speed up button
or speed down button by user.
Charger Socket: There are only used to this wheelchair. Do not use the
sockets to supply to other electrical equipment. Otherwise, it may
damage the wheelchair’s control systerm and its E.M.C
WARNING!
If your wheelchair moves accidentally, please immediately release
the joystick so that the wheelchair will stop moving automatically
unless the joystick is out of order.
CAUTION!
If you connect any device other than the supplied battery
charger into the charger socket on the wheelchair. It could cause
p
ermanent damage to the product.
6.1.2 Batteries and Its Usage
Fully charge your new battery prior to its initial use. This brings the
battery up to about 90% of its peak performance level; Give the battery
another full charge of 8-14 hours and operate your wheelchair again,
the batteries will perform at over 90% of their potential; After four or five
charging cycles, the batteries will be used by 100% and the life time
will be extended. Please replace replace the battery when the battery
fails.The old battery must be returned to supplier because of
environmental pollution.
CAUTION!
T
he wheelchair won't work optimal when the environment
temperature is less than minus 10 ℃ or above 50 ℃.
6.1.3 Charging Batteries
The batter charger is an important part of the wheelchair. The off-board
charger attached to this product can charge its batteries quickly and
easily to make your wheelchair the best.
CAUTION!
The charge of 24V/2A supplied by this company meets
the requirements mentioned in Section I (《General Safety
Requirements》) of medical electrical equipment GB9706.1
-2007. Please be sure to use the charger we supplied and do
not use the other chargers.
Charging the batteries using the off-board charger supplied by us:
■Be certain the controller is powered off and the wheelchair is in the drive
mode, instead of the manual mode.
■Connect the 3-pin output plug of the charger to the controller.
■Connect the power plug of the charger to the standard wall outlet.
The red LED on the charger lights indicating that charging is in progress.
The green LED on the charger lights when the batteries are fully charged.
We recommend you that the batteries should be charged for 8-12 hours.
Remove the charger and power plug when fully charged, and put them
into the bag behind the seatback.
battery gauge
speed light
horn button
speed up button
speed down button
joystick
chearger socket
on/off button
11 12
V. OPERATION V. OPERATION
7


Need help? Post your question in this forum.

Forumrules
1

Forum

pride-igo

Reset search

  • my chair pulls to one side on sloping ground despite trying to keep the joystick straight Submitted on 22-4-2023 at 14:38

    Reply Report abuse
  • how do i charge my igo with the single prong conector Submitted on 18-3-2022 at 11:05

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride IGO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride IGO in the language / languages: English as an attachment in your email.

The manual is 2,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info