722005
14
Zoom out
Zoom in
Previous page
1/44
Next page
14
Mid-size Scooter Series
Anti-Tip Wheels
The anti-tip wheels are an integral and important safety feature of your scooter. They are bolted to the
frame at the rear of the scooter.
PROHIBITED! Do not remove the anti-tip wheels or modify your scooter in any way that
is not authorized by your Provider.
WARNING! The anti-tip wheels may cause interference with the smooth transition of your
scooter when ascending or descending a curb. Contact your authorized Provider for more
information.
Batteries
The batteries store electrical energy that powers your scooter. See III. “Batteries and Charging ” for
information on how to charge your scooter batteries.
Safety Flag Bracket (Optional)
An accessory bracket for installing an optional safety flag is mounted near each anti-tip wheel. See
figure 5. To install the flag, the supplied L-shaped hex key is needed.
To install the safety flag:
1. Remove the cap from the top of the bracket.
2. Loosen the setscrew with the supplied L-shaped hex key.
3. Insert the flag pole into the opening.
4. Tighten the setscrew to complete installation.
II. YOUR SCOOTER
Main Circuit Breaker (Reset Button)
When the voltage in the batteries becomes low or your
scooter is heavily strained because of excessive loads, the
main circuit breaker may trip to protect the motor and
electronics from damage. When the breaker trips, the entire
electrical system shuts down. See figure 6.
The reset button pops out when the breaker trips.
Allow a minute or so for the electronics to “rest.”
Push in the reset button to reset the breaker.
If the breaker trips frequently, you may need to charge
the batteries more often or have your authorized
Provider perform a load test on the batteries.
If the main circuit breaker trips repeatedly, see your
authorized Provider for service.
Figure 6. Main Circuit Breaker (Reset Button)
* 610LX and 710LX
Models Only
14


Need help? Post your question in this forum.

Forumrules
1

Forum

pride-colt-deluxe-2.0

Reset search

  • I bought a 'new' Pride Colt Deluxe 2.0. Later I discovered that both Track Rods where they fit on the Track Rod Ends as best as I could see has some play in them. I rang up the Shop who supplied it, & they sent someone out with a Tie Rap, & then put one on each of them to hold them firmly together. My question is, is this standard procedure when dealing with Mobility Scooters, or are they manufactured 'disabled' to be like the Owner ? Submitted on 3-10-2024 at 20:35

    Reply Report abuse
  • Console shows three green lights are out while charger is flashing fully charged Submitted on 15-10-2023 at 15:01

    Reply Report abuse
  • How do I enable the scooter to go from pushing to driving mode? Submitted on 1-7-2023 at 19:42

    Reply Report abuse
  • Why is my suspension on my pride deluxe Colt so tight Submitted on 21-9-2021 at 11:28

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Colt Deluxe 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Colt Deluxe 2.0 in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info