725398
9
Zoom out
Zoom in
Previous page
1/15
Next page
POWXG7216 EN
Copyright © 2016 VARO NV P a g e | 9 www.varo.com
12 BEFORE OPERATION
12.1 Add or check engine oil level
Remove the oil filler cap/dipstick (9) and wipe it clean.
Insert the oil filler cap/dipstick into the oil filler neck, but do not screw it in, then remove it to
check the oil level.
If the oil level is near or below the lower limit mark on the dipstick, fill with 4-stroke
automotive detergent oil SAE10W-30 to the upper limit mark. Do not overfill.
Reinstall the oil filler cap/dipstick.
12.2 Add or check transmission oil level
Fill the transmission oil tank before use.
Remove the oil filler cap and check the oil level. The oil level should be about 3cm below the
top of the filler, fill with 80W-90 oil if necessary as described above. Wait 15 minutes after
every fill, check the oil level again and fill more oil if necessary. Repeat until the desired oil
level is reached. Do not overfill the tank.
Reinstall the oil filler cap.
12.3 Add fuel to fuel tank
Remove the fuel tank cap (11)
Use unleaded gasoline with a pump octane rating of 86 or higher or use E10 fuel
Use a suitable funnel to fill in the fuel to the engines fuel tank . Do not spill any fuel or overfill
the tank.
13 OPERATING INSTRUCTIONS
13.1 Pre- First - Start Inspection
IMPORTANT! Engine is shipped from factory without oil. Engine oil must be
added before starting engine. SAE10W-30.
IMPORTANT! Transmission is shipped from factory without oil. Transmission
oil must be added before starting cultivator. 80W-90.
Make sure all safety guards are in place and all nuts and bolts are secure.
Check oil level in engine crankcase.
Inspect air filter (12) for cleanliness.
Check the fuel supply. Do not fill petrol tank completely, allow space for fuel to expand.
Be sure spark plug (13) wire is attached and spark plug is tightened securely.
Check depth regulator lever position.
Examine underneath and around engine for signs of oil or fuel leaks.
Inspect fuel hoses for tightness and fuel.
Look for signs of engine damage.
Remove excessive debris from silencer (7) area and recoil starter (14).
13.2 Adjusting the handle height (FIG. 15)
Loosen the height adjusting bolts (t), adjust the height of the handle bar and tighten the
bolts. For normal tilling, the most comfortable position for the operator is if the handle bars
are at waist height.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXG7216 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG7216 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG7216

Powerplus POWXG7216 User Manual - German - 16 pages

Powerplus POWXG7216 User Manual - Dutch - 15 pages

Powerplus POWXG7216 User Manual - French - 16 pages

Powerplus POWXG7216 Additional guide - All languages - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info