POWDP6050 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
9.8 Emptying the tub
▪ Switch off and unplug the machine.
▪ Remove the motor housing (2).
▪ Empty the tub (5).
9.9 Vacuuming up liquids
▪ Check whether the new advanced dust filter has been removed.
▪ Make sure the inside of the tub (5) is clean and free from dust.
▪ Mount the tube (10) to the hose (8) and fit the wet & dry floor brush.
9.10 Drain function (Fig. 4)
▪ When your tank is full of water, just twist the cover of the drain function to let the water out.
9.11 Blow function
▪ Remove dust cover and insert the hose connector into the blowing mouth to use the
blowing function.
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Do not submerge the motor housing in water!
10.2 Cleaning the tub
▪ Empty and clean the tub (5) after each use.
▪ Dry the tub carefully after the machine has been used for vacuuming up liquids.
10.3 Cleaning the advanced filter
▪ Shake out the dust from the filter after each use.
▪ Remove mesh and clean it carefully.
