627530
49
Zoom out
Zoom in
Previous page
1/78
Next page
Owners Manual
R
PowerBoss, Inc. A Member of the Hako Group ©
2007 PowerBoss
®
CORE 50 Sweeper Scrubber
Page 47
PowerBoss
®
The Power of Clean
SCRUB BRUSH REPLACEMENT
The scrub brush features a quick release mechanism which enables the operator to remove
the brush in seconds.
1. Turn the scrub brush by hand until the brush retainer clip is accessible.
2. Squeeze together the two handles of the brush retainer clip to disengage the
brush from the driver.
3. Install the new brush by positioning the drive hub into the pilot hole of the brush.
4. Lift and rotate the brush until the brush retainer clip springs into the locked
position.
5. Check to make sure that the brush is properly engaged.
6. For best access to the left brush, unlatch the engine frame and swing it open
completely. Secure with the locking pin. Access to the left brush is now easier.
CHECKING THE MAIN SQUEEGEE ADJUSTMENT
1. On a level floor, lower the squeegee and drive forward several feet.
2. Observe the rubber contact with the floor. The rubber should have a consistent
flare through its entire width. If the ends are flared more than the center, or if
the center is flared more than the ends, a pitch adjustment is needed. (see
below)
3. If the flare is consistent but too little or too much flare is present, a caster
adjustment is needed.
SERVICE INSTRUCTIONS (CONTINUED)
SCRUB & WATER PICK-UP COMPONENTS
WARNING
Never attempt to perform any service on the equipment or
components until the machine is OFF, the parking brake is
LOCKED and the wheels are CHOCKED.
NOTE
Brushes should be replaced when the bristles are less than ½”
(12.77 mm) long.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerBoss Core 50 - Sweeper Scrubber at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerBoss Core 50 - Sweeper Scrubber in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info