627530
47
Zoom out
Zoom in
Previous page
1/78
Next page
Owners Manual
R
PowerBoss, Inc. A Member of the Hako Group ©
2007 PowerBoss
®
CORE 50 Sweeper Scrubber
Page 45
PowerBoss
®
The Power of Clean
SERVICE INSTRUCTIONS (CONTINUED)
SWEEP COMPONENTS (CONTINUED)
SIDE BROOM HEIGHT (WEAR) ADJUSTMENT
The side broom wear adjustment is controlled in ½” steps. These steps are
accomplished using the two pins in the side broom adjusting block.
1. Lift the hopper cover to the open position.
2. Set the parking brake.
3. Start the engine and lift the hopper.
4. Stop the engine and engage the hopper safety arm.
5. Locate the side broom side block on the side of the hopper. Remove the
pin closest to the actuator and insert on the side of the hopper. Remove
the pin closest to the actuator and insert it into the hole on the opposite
side of the remaining pin while putting tension on the cable. Make sure the
repositioned pin goes through the loop in the cable (inside of the plastic
block). Repositioning the pin places the cable closer to the floor when the
lopper is lowered.
6. Make sure the pins are securely seated.
7. Start the machine and lower the hopper.
8. Close the hopper cover.
SIDE BROOM ANGLE ADJUSTMENT
The side broom can be adjusted to raise or lower the front leading edge of the broom. To
adjust:
1. Locate the two ½” hex nuts on the plate behind the side broom motor. This
plate is located between the motor and the hopper.
2. Loosen both nuts using a ½” wrench.
3. Move the broom to the desired angle.
4. Retighten both nuts.
CAUTION
DO NOT RELY UPON THE HYDRAULIC CYLINDER TO KEEP THE
HOPPER RAISED FOR MAINTENANCE. ALWAYS ENGAGE THE
SAFETY ARM BEFORE GETTING UNDER THE HOPPER.
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerBoss Core 50 - Sweeper Scrubber at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerBoss Core 50 - Sweeper Scrubber in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info